Resistance: find the equivalent resistance.

AI Thread Summary
To find the equivalent resistance in a circuit, identify resistors in series or parallel. Resistors in series simply add together, while those in parallel require the inverse formula for total resistance. Start by simplifying pairs of resistors, calculating their effective resistance, and replacing them with a single equivalent resistor. This process is repeated until the entire circuit is simplified to a single equivalent resistance. Ultimately, the final resistance can be calculated by combining the results from both series and parallel configurations.
LostShadow
Messages
12
Reaction score
0

Homework Statement



resistance.png


Homework Equations



Resistors in series (in a straight line) add. Like R + R = 2R.

And if in parallel, they inversely add.

1/R_total = 1/R1 + 1/R2

So, I have no idea how to "simplify" this.

Basically trying to find the total resistance.

Thanks.
 
Physics news on Phys.org
Start by identifying resistors which are in series or parallel. What do you find?
 
Resistors in series or parallel that could be in series or parallel with others resistors that could be in series and parallel...
 
Start with some pair of resistors that you can analyse without having to consider a third. That could be two in series with no other resistor connected to their junction, or two directly in parallel - i.e. that make a direct connection to each other at each end. Having found such pair, figure out what the effective resistance of the pair is and replace the pair by a single equivalent resistor. Repeat.
 
1) if R=1ohm

R eq= 2.5ohms

relation: (2R+R)x(2R+R) / (2R+R) + (2R+R) + R

2) inverse add last two R, answer will series add with the R in the line, u will eventually see only two R in parallel, then inverse add these last two to get your answer.
 
I multiplied the values first without the error limit. Got 19.38. rounded it off to 2 significant figures since the given data has 2 significant figures. So = 19. For error I used the above formula. It comes out about 1.48. Now my question is. Should I write the answer as 19±1.5 (rounding 1.48 to 2 significant figures) OR should I write it as 19±1. So in short, should the error have same number of significant figures as the mean value or should it have the same number of decimal places as...
Thread 'A cylinder connected to a hanging mass'
Let's declare that for the cylinder, mass = M = 10 kg Radius = R = 4 m For the wall and the floor, Friction coeff = ##\mu## = 0.5 For the hanging mass, mass = m = 11 kg First, we divide the force according to their respective plane (x and y thing, correct me if I'm wrong) and according to which, cylinder or the hanging mass, they're working on. Force on the hanging mass $$mg - T = ma$$ Force(Cylinder) on y $$N_f + f_w - Mg = 0$$ Force(Cylinder) on x $$T + f_f - N_w = Ma$$ There's also...
Back
Top