Robot Materials: Light & Economical Solutions

  • Thread starter Thread starter becheras
  • Start date Start date
  • Tags Tags
    Materials Robot
AI Thread Summary
For designing a small humanoid robot, aluminum is recommended due to its lightweight, cost-effectiveness, and strength, making it suitable for non-destructive applications. Wood is mentioned but may not be the best choice for a lightweight design. Casting resin is suggested for achieving humanoid shapes, while acrylic sheets are a viable option for other parts. The focus is on finding materials that balance lightness and economy without compromising structural integrity. Selecting the right materials is crucial for the overall performance and feasibility of the robot.
becheras
Messages
4
Reaction score
0
I am currently designing a small humanoid. What are the possible materials for the body? I would like the robot to be light and economical.
 
Engineering news on Phys.org
Wood?
 
clearly you should first investigate alluminum because obviously its cheap and lightweight and strong enough for robots that are not designed to withstand destructive forces.
 
Casting resin if you want humanoid rondure. Acrylic sheet otherwise.
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »
Thread 'What's the most likely cause for this carbon seal crack?'

Thread 'What's the most likely cause for this carbon seal crack?'

We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...
View full post »

Similar threads

Can Ancient Metalworking Techniques Enhance Modern Robotic Arm Design?
Replies
6
Views
1K
How to begin in studying Mechanics and ME?
Replies
16
Views
1K
Supporting structures used in machines/production lines
Replies
12
Views
2K
Big Robot- Lattice boom crane - calculating maximum stress
Replies
2
Views
1K
Cardboard Robotics: Building a Desktop Robotic Arm
Replies
9
Views
3K
Looking for Push-along walking "robot"
Replies
3
Views
1K
Crazy idea for battle bot. Can it work?
Replies
3
Views
1K
Optimizing Robot Design: Heuristics for Efficient Performance
Replies
5
Views
2K
Torque required to move robot arm (special linkage)
Replies
3
Views
2K
Building prosthetic feet for my robot
Replies
15
Views
2K

Hot Threads

Recent Insights

Back
Top