Oscillations of 1.5 kg Block on Spring: Frequency and Stretch

AI Thread Summary
A 1.5 kg block attached to a spring with a force constant of 300 N/m oscillates with a frequency of 2.3 Hz after being pulled down 2.0 cm and released. The maximum stretch of the spring during oscillations is 6.9 cm, while the minimum stretch is 2.9 cm. The equilibrium position is determined by the weight of the block, and the oscillation occurs around this point. The calculations involve using the spring constant and understanding the relationship between force, displacement, and equilibrium. The discussion clarifies how to approach the problem of finding the maximum and minimum stretch of the spring.
Dooga Blackrazor
Messages
258
Reaction score
0
1. A block of mass 1.5 kg is attached to the end of a vertical spring of force constant k=300 N/m. After the block comes to rest, it is pulled down a distance of 2.0 cm and released.
(a) What is the frequency of the resulting oscillations?
(b) What are the maximum and minimum amounts of stretch of the spring during the oscillations of the block?

(a) 2.3 Hz
(b) 2.9 cm and 6.9 cm


I used the formula T = 2(pie)(squaroot of m/k) with f = 1 /T and found the first answer; however, I'm now sure how to calculate the answers for the second part of the question. F = k*x (spring constant times displacement, but I'm not sure how that factors into the two answers.

Thanks in advance.
 
Physics news on Phys.org
Dooga Blackrazor said:
I'm now sure how to calculate the answers for the second part of the question. F = k*x (spring constant times displacement, but I'm not sure how that factors into the two answers.
They are measuring the stretch of the spring from its unstretched position (before the mass is attached). First find out where the equilibrium position is when the mass is attached. Then realize that the mass will oscillate about that point with the given amplitude.
 
Thanks - I've got it now.
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Trying to understand the logic behind adding vectors with an angle between them'
My initial calculation was to subtract V1 from V2 to show that from the perspective of the second aircraft the first one is -300km/h. So i checked with ChatGPT and it said I cant just subtract them because I have an angle between them. So I dont understand the reasoning of it. Like why should a velocity be dependent on an angle? I was thinking about how it would look like if the planes where parallel to each other, and then how it look like if one is turning away and I dont see it. Since...
Back
Top