Simple continuous back-and-forth linear movement

AI Thread Summary
A device is needed to create continuous back-and-forth linear movement for flapping wings, with linear actuators being a potential solution, though they typically require manual control. A slider-crank mechanism is suggested as a way to convert continuous rotation into reciprocating motion, but the user lacks the resources to build one. The user seeks a commercially available solution, specifying a stroke length of about one foot, a frequency of 16 revolutions per minute, and a force limit of 30 pounds. An alternative idea involves using a linear actuator with a device to reverse polarity every four seconds to achieve the desired motion. The discussion emphasizes the need for practical advice on purchasing or implementing such a mechanism.
bimusicmaker
Messages
3
Reaction score
0
I need to purchase a device that will push something forward and backward continuously, in order to make wings flap like a bird. Linear actuators seem to be the right thing to buy, except these require pressing buttons to go forward and then back. What can I buy/what can I do that will allow a linear actuator (or something similar) to continuously move back-and-forth?

I much rather buy something that already does this than to build a machine or program anything.
 
Engineering news on Phys.org
Why not use a simple slider-crank mechanism? This will convert continuous rotation into a reciprocating motion. Sounds to me like what you want.
 
I agree, however I do not have the resources to make one myself. Do you know of anything I can buy that will accomplish this?
 
You don't say anything about the stroke, frequency , force, et, required, so no, I don't know where you can buy an undefined mechanism.
 
The stroke would ideally be around a foot long, frequency would ideally be around 16 rev/min. Force no more than 30 lbs.

Another option I was considering would be to use a linear actuator connected to some sort of device that will reverse polarity every 4 seconds or so in order to achieve this reciprocating motion. I am pretty unexperienced with this sort of thing so any advice would be appreciated.
 
How did you find PF?: Via Google search Hi, I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere. The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary The bubble is formed at the tip...
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'd like to create a thread with links to 3-D Printer resources, including printers and software package suggestions. My motivations are selfish, as I have a 3-D printed project that I'm working on, and I'd like to buy a simple printer and use low cost software to make the first prototype. There are some previous threads about 3-D printing like this: https://www.physicsforums.com/threads/are-3d-printers-easy-to-use-yet.917489/ but none that address the overall topic (unless I've missed...
Back
Top