Small gas engine electric generator ?

AI Thread Summary
Tying two generators together to power a house is not advisable due to insufficient current capacity. The older 10 hp generator provides only 15 amps, while the 5.5 hp generator is even less powerful, making them inadequate for running high-demand appliances like an AC and dryer simultaneously. Proper synchronization of generators requires matching frequency, phase angle, and amplitude, which is complex and risky without specialized equipment. Instead of paralleling the generators, splitting the load between them is a safer alternative. For reliable power, investing in a larger generator is recommended.
zanegrey
Messages
1
Reaction score
0
hi,
i want to know if i can tie 2 generators together to get enough amps to run my house.

i have an older 10 hp 4.5 k watt genset and a 5.5 hp 3 k watt genset.

the 4.5 k genset is a 240 plug in but only 15 amps

my ac is 240 at 30 amps
and dryer require 220 at 30 amps.


thanks
 
Engineering news on Phys.org
Doesn't sound like a good idea to me. Even if you could, you wouldn't have enough current to run your house.
BTW Welcome to PF
 
If you want to run the AC and dryer at the same time, those generators aren't powerful enough.
 
I'm not an expert, and have never done this, but there seems to be very few replies, so here's something I found when I quickly googled your query yesterday (the warnings, pitfalls, and a method for linking the generators):

http://yarchive.net/car/rv/generator_synchronization.html

When you're trying to put generators in parallel, it's best to use generators designed for this purpose (I think there're a few Hondas that do this). Otherwise, you'll need to match frequency, phase angle, and (preferably) amplitude, or else danger ensues (mostly to the generators, but also possibly to you and your house).

These aren't exactly the necessities of life, however. If you're going off the grid, or want to prepare for (prolonged) power outages, could you rough it? That or just buy a bigger generator.
 
I think it is a bit dodgy to parellel up two different generators.. Tricky enough if they are identical. Trying to alter frequency and phase with simple generators wouldn't be easy.

You could get large circulating currents. You would need a syncroscope (expensive??) to get the phasing right and suitable switch gear.

Why do you need to do it anyway??

Only other way is the split the load between the two.. Much safer.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top