Can capacitors self charge in a circuit?

AI Thread Summary
Capacitors can indeed self-charge in a circuit, accumulating a static charge over time when left open circuit. This phenomenon can occur with various types of capacitors, including film types, which may retain voltage after being disconnected from power. For practical applications, users can build devices to discharge capacitors safely, such as using a switch to control the charging and discharging process. It is crucial to handle high voltage capacitors with care due to the potential for dangerous voltage levels. Overall, understanding the self-charging behavior of capacitors is important for safe and effective circuit design.
pandu
Messages
1
Reaction score
0
Dear All
Suppose there is a powered on circuit which consists of a capacitor.Can a static charge come and reside on the capacitor which is working in the circuit ?

Thanks
 
Engineering news on Phys.org
Capacitors can self charge.
You can short a capacitor, remove the short and some time later (hours, days, weeks or maybe months) the capacitor will self charge to some voltage.

High voltage, high power capacitors should have a wire shorting the capacitor when not in use.
 
How could I build a device to release the static charge of a capacitor by flipping a switch? I Would like to use a 9V battery and a 100uf 330V camera flash capacitor. Set a SPDT to a charge mode, wait, flip switch to discharge and see spark jump across a gap. What should I make the gap out of? Thanks
 
Some capacitors self charge and some don't

My experience has been with film type capacitors.

If you wish to check capacitors for self charge, get some old used capacitors.
Let the capacitors sit open circuit for several days.
Place a high impedance voltmeter across the capacitors. The voltmeter should read a voltage and the voltage should decrease as the capacitor discharges.

If testing large high voltage capacitors, be careful, they can charge up to dangerous voltages.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
Back
Top