Thickness of hot chocolate varying with temperature

AI Thread Summary
Hot chocolate thickens at room temperature due to evaporation, which removes water and increases viscosity. When refrigerated, it cools quickly, allowing less water to escape, but the chocolate particles settle at the bottom, resulting in a thinner liquid when stirred. The cooling process alters the molecular structure, affecting viscosity regardless of water loss. Even after stirring, the chocolate's properties change when cold, leading to a less viscous consistency compared to when it was hot. Understanding these factors clarifies the differences in texture between hot and cold hot chocolate.
Arak
Messages
2
Reaction score
0
I noticed recently that hot chocolate when left on the table for a while and starts cooling at room temperature, starts getting thicker (more viscous). However, when it was put in the fridge overnight and got completely cold it became more liquid (less viscous). Why does this happen? Can someone please help me understand this? Thanks.
 
Science news on Phys.org
If you leave it out, it takes a while for the hot chocolate to cool. During this time water is evaporating as steam, which removes the water from the mug but leaves the chocolate. Putting it inside a refrigerator cools it down much quicker, which would allow less water to escape. However, I think the key difference here is that hot chocolate left overnight tends to settle at the bottom of the mug. Hence it is less viscous when you take a sip because half the chocolate is at the bottom.
 
Thank you for your response. But I was wondering, the hot choco has already lost some water which is what makes it thick and it's the same mug that was put in the refrigerator, so how does it regain the lost water?

Also, even if the chocolate had settled in the bottom, after stirring it, it was still not as viscous as it was when it was hot. Why is that?
 
Been around 40 years since I took basic physics in college and while I remember doing some examples of insulation values / energy conduction, I doubt I could to the math now even if I could find the formulas. I have some some corrugated plastic sheet (think of the plastic signs you see on the side of the road) that is used in bee hives. Also have some used in a green house though a bit different in dimensions than this example but the general approach should still apply. Typically, both...
Problem: You’re an Uber driver with a Tesla Model 3. Today’s low: 30F, high: 65F. You want to reach a USD$ profit target in the least number of hours, but your choices could have added cost. Do you preheat the battery only when you are headed to the charging station (to increase the charging rate by warming the battery — however the battery might not be “warm enough” when your reach the charger and thus slower charging rates), or do you always “navigate to the charger” the entire day (which...
Thread 'Is Callen right in claiming dQ=TdS for all quasi-static processes?'
Hello! I am currently reading the second edition of Callen's Thermodynamics and an Introduction to Thermostatistics, and I have a question regarding Callen's definition of quasi-static. On page 96, Callen says: Another way of characterizing Callen's definition is that a process is quasi-static if it traces out a continuous curve in the system's configuration space. So far it's all well and good. A little later, Callen claims that the identification of $$TdS$$ as the heat transfer is only...
Back
Top