Understanding Resistance in Ohm's Law: Graph Analysis & Explanation

  • Thread starter Thread starter ninjadrummer8
  • Start date Start date
  • Tags Tags
    Law Ohms Ohms law
AI Thread Summary
The discussion centers on analyzing a current versus voltage graph to understand resistance behavior according to Ohm's Law. Initially, the resistance is constant and linear, but it suddenly increases exponentially at higher currents, indicating a transition from ohmic to non-ohmic behavior. This change is attributed to temperature dependence, as resistance can rise when a resistor heats up. The conversation also explores real-world examples, such as light bulbs and heating elements, which exhibit similar characteristics under certain conditions. Overall, the graph illustrates the complexity of resistor behavior beyond ideal conditions.
ninjadrummer8
Messages
24
Reaction score
0

Homework Statement



q7.jpg


Graph of current vs voltage. What is happening to the resistance after the linear portion of the graph and why.

Homework Equations



none

The Attempt at a Solution



the line is the resistance and it follows ohms law for a while (it is constant and independent of V and I), but then suddenly jumps up exponentially at a high value of I... I can't figure out what could cause this. it doesn't say whether this resistor is ohmic or not, but graphs of nonohmic resistors I've seen are exponential all the time not just at high current
 
Physics news on Phys.org
you must know that resistance is temperature dependent. notice the linear relationship between current and electric potential until the the curve. At the point of the curve, resistance is no longer a constant. thus, you see the curve.
 
The curve appears is too crude to obtain information. Is it supposed to look linear toward the bottom?
 
yes, its linear, then suddenly grows exponentially
 
What happens to a resistor as the current through it increases without bound?
 
ninjadrummer8 said:
yes, its linear, then suddenly grows exponentially

What if it is almost linear, but not exactly so?

What circuit elements have you learned of? Can you think of any simple component network that would produce a curve like that given the circuit elements you have learned?
 
Phrak said:
What if it is almost linear, but not exactly so?

What circuit elements have you learned of? Can you think of any simple component network that would produce a curve like that given the circuit elements you have learned?

It's probably accurate to consider it linear up until the time it becomes exponential (of course no real part is truly linear but this is coursework, the land of ideals!); it seems a safe assumption that that was specified in the problem. And yes, there really is a real-world fundamental circuit element which will behave like that, if pushed.
 
You are sitting in a dark room and you walk over to the switch on the wall and you turn on the ? and then you can see OK. What is the ?...?
 
negitron said:
It's probably accurate to consider it linear up until the time it becomes exponential (of course no real part is truly linear but this is coursework, the land of ideals!); it seems a safe assumption that that was specified in the problem. And yes, there really is a real-world fundamental circuit element which will behave like that, if pushed.

I think it's too crude.

vk6kro thinks it's a light bulb. Could be.

Exponentials look very flat at the bottom.
http://upload.wikimedia.org/wikipedia/commons/5/53/Exponential.png"

Ambiguous homework questions are common enough. Is that your own rendition of the curve, or are you reposting it?
 
Last edited by a moderator:
  • #10
If we took the graph as being absolutely correct, there is another possibility.

If you had a resistor (like the heating element in a fan heater) which had a powerful stream of air being forced past it, you would get it behaving exactly like a resistor (and hence the straight line graph) while the stream of air was able to carry away any heat generated.

There would come a point, though, when the temperature did start to rise and the resistance of the resistor would start to increase. After that, you could get the non linear behaviour shown on the right of the graph.
 
Last edited:
Back
Top