What are the key factors affecting high speed train aerodynamics?

AI Thread Summary
Key factors affecting high-speed train aerodynamics include the drag coefficient, which is influenced by the train's shape and the surrounding airflow. The principles of aerodynamics for trains are similar to those for cars, emphasizing the importance of streamlined designs. A significant challenge for high-speed trains is the compression wave generated when entering tunnels, which can disrupt aerodynamic performance. This wave can travel faster than the train and cause successive reflections that impact airflow. Understanding these dynamics is crucial for improving the efficiency and performance of high-speed trains.
himanshu121
Messages
649
Reaction score
1
Hi, can anyone please tell me any good book on the subject, even any research paper will do, we are actually doing summer project in which we are estimating the drag coefficient on the bluff body like train Coach, using commercial softwares like Fluent n Gambit.Please if anyone has the info regarding the high speeed aerodynamics then pls share it with me

Thanks
regards
Himanshu
 
Engineering news on Phys.org
Since it is a train, it should be the same principles used on cars.

The aerodynamics should be very very close if not identical.

http://www.me.ttu.edu/UserFiles/File/Maxwell%20Spr%2006%20Auto%20Sys/Accel%20&%20Res%20to%20Motion.pdf

Try that file. I don't know how long it will be up so you may want to save it. It has some aerodynamic stuff regarding drag coefficients and drag equations.

Hopefully that helps at least a little.
 
mpm said:
http://www.me.ttu.edu/UserFiles/File/Maxwell%20Spr%2006%20Auto%20Sys/Accel%20&%20Res%20to%20Motion.pdf

.

I hope the OP wants to do something more elaborated. I still don't see where is the aerodynamics in your link. There are only tables and coefficients.

I am not an expert in hs train aerodyn, but as far as I know there is currently one issue of interest. HS trains get usually in troubles when passing through tunnels. That's because of the compression wave which travels in the air standing inside the tunnel casued when the train gets in. That wave breaks the aerodynamic performance of the train. Even though the wave may travel faster than the train, the successive reflections at the end of the tunnel flow again over the train. In fact that's a nice problem of propagation along characteristics and Riemann invariants.
 
thnks for info clausius
 
Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
Thread 'What's the most likely cause for this carbon seal crack?'
We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...
Back
Top