What Does Piping Whiplash Mean?

  • Thread starter Thread starter Jack8rkin
  • Start date Start date
  • Tags Tags
    Piping
AI Thread Summary
Piping whiplash refers to the sudden, forceful movement of piping due to rapid depressurization, which can occur when a hole forms in a pipe. This event causes high-pressure gas to escape sideways, generating a significant lateral force that can damage the pipe's supports and surrounding equipment. The term is rarely found in searches, indicating its specialized usage in engineering contexts. Understanding this phenomenon is crucial for assessing the risks associated with pressurized systems. Proper safety measures are essential to mitigate potential damage from such incidents.
Jack8rkin
Messages
52
Reaction score
0
Hey everyone!
Could you please explain to me what the term "piping whiplash" stands for?
It is a very rare combination in the google search, but we have encountered this term in our translations.

Thanks
 
Engineering news on Phys.org
Here is the context:
"Rapid depressurization event consequences may include an unfiltered discharge of the primary system inventory into the atmosphere as well as damage to equipment outside the primary system from a hot helium jet or from piping whiplash".
 
If you burst a hole in the side of a pipe, the high pressure gas will blow out sideways and apply a sideways force to the pipe in the opposite direction.

This force can be big enough to break the connections that are supporting the pipe and allow it to thrash around, damaging anything that it hits.
 
Thank you! I suspected it was like that. Thanks for help.
 
Hi all, I have a question. So from the derivation of the Isentropic process relationship PV^gamma = constant, there is a step dW = PdV, which can only be said for quasi-equilibrium (or reversible) processes. As such I believe PV^gamma = constant (and the family of equations) should not be applicable to just adiabatic processes? Ie, it should be applicable only for adiabatic + reversible = isentropic processes? However, I've seen couple of online notes/books, and...
Thread 'How can I find the cleanout for my building drain?'
I am a long distance truck driver, but I recently completed a plumbing program with Stratford Career Institute. In the chapter of my textbook Repairing DWV Systems, the author says that if there is a clog in the building drain, one can clear out the clog by using a snake augur or maybe some other type of tool into the cleanout for the building drain. The author said that the cleanout for the building drain is usually near the stack. I live in a duplex townhouse. Just out of curiosity, I...
I have an engine that uses a dry sump oiling system. The oil collection pan has three AN fittings to use for scavenging. Two of the fittings are approximately on the same level, the third is about 1/2 to 3/4 inch higher than the other two. The system ran for years with no problem using a three stage pump (one pressure and two scavenge stages). The two scavenge stages were connected at times to any two of the three AN fittings on the tank. Recently I tried an upgrade to a four stage pump...
Back
Top