Trouble with Plasma Frequency Calculation

AI Thread Summary
The discussion centers on a plasma frequency calculation that appears incorrect, with a reported frequency of 399 Hz significantly lower than the expected 1160 KHz. Concerns are raised about the electron density value of 1974 m-3, which is deemed too low compared to typical ionosphere densities around 10^10 m-3. A calculation error is identified where the frequency was not squared, leading to a drastic underestimation of electron density. The index of refraction for the ionosphere is discussed, with a suggestion to adjust the frequency based on the given parameters. The conversation highlights the importance of accurate calculations in plasma physics.
Blanchdog
Messages
56
Reaction score
22
Homework Statement
What is the complex refractive index of the ionosphere for an AM radio station at 1160 KHz? Is this frequency above or below the plasma frequency? Assume an electron density of 1974 electrons per cubic meter.
Relevant Equations
The Plasma frequency is given by ##\omega_p^2=\frac{N q_e }{\epsilon_0 m_e}##
The complex index of refraction is given by ## \mathcal{N}^2 = (n + \text i\kappa)^2 = 1+ \frac{\omega_p^2}{\omega_0^2-\text i \omega \gamma - \omega^2}## However, since we are dealing with a plasma, ##\omega_0 = 0## and ##\gamma = 0## and so ## \mathcal{N}^2 = 1- \frac{\omega_p^2}{ \omega^2}##
This would appear to be a straightforward algebra problem, but it just doesn't pass the smell test for me. The issue might be with the number of electrons per cubic meter, as that was calculated in a previous problem, so let me know if that number seems wrong.

My plasma frequency (##\nu##) not (##\omega##) came out to 399 Hz, which is nowhere near 1160 KHz. I calculated my index of refraction to be almost arbitrarily close to 1 with no imaginary part, which seems weird since the problem asked for a complex index of refraction.
 
Physics news on Phys.org
Blanchdog said:
The issue might be with the number of electrons per cubic meter, as that was calculated in a previous problem, so let me know if that number seems wrong.
Your value of 1974 m-3 for the electron density seems to be way too small. I think ionosphere electron densities are on the order of 1010 m-3.
 
Blanchdog said:
The Plasma frequency is given by ##\omega_p^2=\frac{N q_e }{\epsilon_0 m_e}##
##q_e## should be squared.
 
TSny said:
##q_e## should be squared.
I think that's just a typo since it doesn't look like I forgot to square it in my written work.

I calculated the number of available free electrons as follows, then was asked to assume the same number of free electrons:

The index of refraction of the ionosphere is ##\mathcal{N} = 0.9## for an FM station at ##\nu =\frac{\omega}{2\pi} = 100##MHz. Assume ##\omega_0 = \gamma = 0##.

Then
$$\mathcal{N}^2 = 1+ \frac{\omega_p^2}{\omega_0^2-\text{i}\gamma\omega -\omega^2}=1-\frac{\omega_p^2}{\omega^2} = 1- \frac{Nq_e^2}{\epsilon_0 m_e \omega^2}$$
Rearranging, we get
$$N = \frac{(1-\mathcal{N}^2)\omega^2\epsilon_0 m_e}{q_e^2}$$

Aaaaand I just found my error. When I did this on paper I forgot to square ##\omega##, decreasing my electrons per cubic meter by 8 orders of magnitude or so. Thanks for the estimate on ionosphere densities, I might never have known something was amiss otherwise.
 
  • Like
Likes russ_watters and TSny
For @Blanchdog
Given that you said you know
## \mathcal{N}^2 = 1- \frac{\omega_p^2}{ \omega^2}##
And that The index of refraction of the ionosphere is N=0.9 for an FM station at ν=ω2π=100MHz.

Why didn't you just change the frequency ##\omega## by 1.16/100 ?

edited by the lets-be-nice police to save this post.
 
Last edited by a moderator:
hutchphd said:
For @Blanchdog
Given that you said you know
## \mathcal{N}^2 = 1- \frac{\omega_p^2}{ \omega^2}##
And that The index of refraction of the ionosphere is N=0.9 for an FM station at ν=ω2π=100MHz.

Why didn't you just change the frequency ##\omega## by 1.16/100 ?
1) Your calculation of ##\nu## is wrong.
2) The arithmetic of that part of the problem wasn't even part of the question because it's so trivial

Edits were done by mentor: (the lets-be-nice police have interceded here to save this post)
 
Last edited by a moderator:
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Back
Top