What programs effectively approximate fluid flow using Navier Stokes equations?

AI Thread Summary
Several computational fluid dynamics (CFD) programs effectively approximate fluid flow using the Navier-Stokes equations, with FLUENT being a notable example. These programs are designed for general flow applications beyond simple linear flow in pipes. Users can find various options by searching for Finite Element Fluid Mechanics or Computational Fluid Dynamics software. Additionally, some programs cater specifically to turbulent flow scenarios. Overall, suitable software exists for those seeking to model complex fluid dynamics.
OffTheRecord
Messages
17
Reaction score
0
Does anyone know of a program that can give a good approximation of fluid flow based on the Navier Stokes equations? I know there are FEA programs out there that do linear flow, like in pipes, but what I'm looking for is general flow, for applications that aren't constrained to a pipe. Does such an animal exist?

Thanks!
 
Engineering news on Phys.org
OffTheRecord said:
Does anyone know of a program that can give a good approximation of fluid flow based on the Navier Stokes equations? I know there are FEA programs out there that do linear flow, like in pipes, but what I'm looking for is general flow, for applications that aren't constrained to a pipe. Does such an animal exist?

Thanks!

Yes. There are several computational fluid dynamics (CFD) FEM programs that do this. One of the is FLUENT. Just google Finite Element Fluid Mechanics or Computational fluid Dynamics. There are also programs out there for turbulent flow.
 
Last edited:
Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
Thread 'What's the most likely cause for this carbon seal crack?'
We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...
Back
Top