What's the part called that converts motor power into electricity?

AI Thread Summary
The component that converts motor power into electricity is typically called an alternator in modern cars, while older vehicles may use a generator. The main difference is that an alternator produces alternating current (AC), whereas a generator produces direct current (DC). Terminology can vary, with terms like dynamo and magneto also used in different contexts. When considering a purchase, it's essential to specify the desired output characteristics, such as voltage, current type, and whether it needs to be high or low. Understanding these distinctions is crucial for selecting the right device for specific electrical needs.
david1443
Messages
4
Reaction score
0
What's the part called that converts spinning, rotor, motor power into electricity?

If I were to buy one what would I call it?

Regards, David
 
Engineering news on Phys.org
Modern cars use an alternator, older ones may have a generator.
 
Whats the difference? An alternator is a small generator isn't it?
 
Alternator, generator, dynamo, magneto... then there are also a pile of electrostatic machines too...


If you were to buy one, the question is; what do you want it to do?

High voltage, high current, low voltage, low current, AC, DC, pulsed..?
 
An alternator produces AC a generator DC.
 
How did you find PF?: Via Google search Hi, I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere. The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary The bubble is formed at the tip...
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'd like to create a thread with links to 3-D Printer resources, including printers and software package suggestions. My motivations are selfish, as I have a 3-D printed project that I'm working on, and I'd like to buy a simple printer and use low cost software to make the first prototype. There are some previous threads about 3-D printing like this: https://www.physicsforums.com/threads/are-3d-printers-easy-to-use-yet.917489/ but none that address the overall topic (unless I've missed...
Back
Top