Coefficient of friction problem

AI Thread Summary
The problem involves determining the coefficient of friction for a block of wood sliding down an inclined plane at an angle of 17.157 degrees. The relevant equation for calculating the coefficient of friction is based on the tangent of the angle of elevation. The initial calculation suggests an answer of 2.074, but there is uncertainty regarding the method used to arrive at this figure. Forum participants emphasize providing hints rather than complete solutions to help the original poster understand the problem better. Clarification on the calculation process is requested to ensure accuracy.
emscare
Messages
9
Reaction score
0

Homework Statement



A block of wood is sitting on an inclined plane. One end of the plane is rised until the wood block slides down. The wood block slides down when the plane has an angle of 17.157
degrees . What is the coefficient of friction?


Homework Equations



F/R

The Attempt at a Solution


opposite/ adjacent = tan theta how i worked out my angle

answer should be 2.074 at the end

Angle of elevation, at which the block slid down the ramp, in degree’s (˚)is an average
= tan-1 (opp. /adj.)
= angle θ
 
Physics news on Phys.org
Please show how you arrived at the answer...something is not right.
 
Hey ainhaini,
Since you are new to PF I should tell you that you are not supposed to give the whole answer. Just give hints or solve the doubt
 

Thread 'Rolling without slipping on a curved surface'

Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
View full post »
Thread 'Voltmeter readings for this circuit with switches'

Thread 'Voltmeter readings for this circuit with switches'

TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
View full post »

Similar threads

Finding the work done by a block
Replies
4
Views
3K
Question Concerning The Coefficient of Friction: Block on a Rough Inclined Plane
Replies
5
Views
2K
Does coefficient of kinetic friction depend on speed?
Replies
16
Views
5K
A problem from a physics national competition
Replies
13
Views
1K
Variable friction on an inclined plane and maximum velocity
Replies
33
Views
3K
Physics homework help needed -- A mass sliding down a ramp with friction
Replies
14
Views
3K
Inclined Plane Static Friction Coefficient
Replies
11
Views
4K
Coefficient of Friction when Normal Force is Reduced [HS]
Replies
5
Views
2K
Calculating acceleration from the coefficient of kinetic friction
Replies
48
Views
8K
Dynamics problem involving an inclined plane and Friction
Replies
1
Views
2K

Hot Threads

Recent Insights

Back
Top