Energy of Capacitor in RC Circuit

AI Thread Summary
In an RC circuit with a battery, resistor, and capacitor, when the switch is closed, the capacitor charges over time, ultimately storing energy. The energy stored in the capacitor at full charge is given by U(∞) = 1/2 CV_0^2, while the total energy supplied by the battery is C V_0^2. This indicates that only half of the energy from the battery is stored in the capacitor, with the other half dissipated as heat in the resistor. The relationship between current, charge, and voltage is governed by Kirchhoff's laws, which help derive the energy equations. Ultimately, the analysis confirms that the energy supplied to the circuit is twice that stored in the capacitor.
buttermellow7
Messages
9
Reaction score
0

Homework Statement


The circuit consists of a battery, switch, resistor, and capacitor connected in a loop in series. When the switch is closed at time t=0, a time-dependent current flows out of the battery and charges the capacitor. The capacitor is fully charged at time t=infinity. Show that only half of this energy supplied by the battery ends up being stored in the fully charged capacitor.

Homework Equations


V(t)=V_0(1-e^{-t/\tau}
U=1/2CV^2
P=IV=V^2/R=\dot{E}

The Attempt at a Solution


U(\infty)=1/2CV_0^2=\frac{QV_0}{2}=\frac{V_0^2}{2}

I'm confused about where my extra factor of V0 is coming from. Do I need to use the power equation?
 
Last edited:
Physics news on Phys.org
\frac { Q V_0 } {2}

is the correct expression for the energy stored in the capacitor. The next step is wrong.

Try to show that the total energy delivered by the battery is twice as large.
 
Energy supplied by battery up to any point is qVo
here q is total charge supplied up to that point

use this and qVo/2 for capacitor at t = ∞
 
The instantaneous power delivered to a component is given by

I * V

where the I is the current through the component, and V is the voltage across the component.

Note that the current through the resistor and capacitor are the same, because of Kirchoff's current law:

<br /> I(t) = \frac{dQ(t)}{dt} = C \frac{dV(t)}{dt}<br />

where Q(t) is the charge on the capacitor at a time t, and the voltage V_R across the resistor plus the voltage V_C across the resistor is:

<br /> V(t) = V_R + V_C = V_o <br />

Since the voltage across the capacitor and resistor always sums to V_o (Kirchoff loop law).

The total energy delivered to the component is given by the time integral of this expression, since power is the time derivative of the energy. So the total energy delivered to the RC circuit is
<br /> C \int_0^{t_o} \frac{d V(t)}{d t} V_o d t<br />

The fundamental law of calculus says this is equal to:

<br /> C V_o \left( V(t_o) - V(0) \right)<br />

There is no initial voltage across the capacitor so V(0) = 0. t_o is infinite so V(t_o) = V_o. So the total energy expended to charge the capacitor is:

<br /> C V_o^2<br />

Which is twice the energy stored in the capacitor.
 
Last edited:
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
Back
Top