Unique Bonds: Diborane's Bent Bond Structure

  • Thread starter Thread starter ChiralWaltz
  • Start date Start date
  • Tags Tags
    Bonds
AI Thread Summary
Diborane features a unique "bent bond" structure, characterized by three-center two-electron bonds where hydrogen atoms connect boron atoms. This structure expands the understanding of chemical bonding beyond traditional covalent, resonance, and ionic bonds. The discussion highlights the significance of diborane in illustrating alternative bonding phenomena, prompting interest in exploring other unique bond types. A Wiki navigation box on chemical bonding is suggested for further exploration of related topics.
ChiralWaltz
Messages
161
Reaction score
5
I stumbled across diborane yesterday and was quite surprised to see the "bent bond" structure it utilizes as well as the hydrogens serving as a connection between the boron atoms.

Are there any other unique bonds like this? All I had been taught about was covalent, resonance type/aromatic and ionic.
 
Chemistry news on Phys.org
Diborane is an example of a three-center two-electron bond. This Wiki navigation box on chemical bonding at the bottom might be of interest, as it links to some other interesting chemical bond-related phenomenona.
 
Mike H said:
This Wiki navigation box on chemical bonding at the bottom might be of interest, as it links to some other interesting chemical bond-related phenomenona.

it is of great interest. thank you.
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...
Back
Top