Planetary Motion - Energy Totals and Binding Energy

AI Thread Summary
The discussion focuses on calculating the energy required to place a 2000 kg satellite into a circular orbit at 500 km above Earth and the additional energy needed for it to escape Earth's gravitational field. The initial calculations yielded incorrect results, prompting a review of the gravitational potential energy and the distinction between total energy and work. It was clarified that the total energy in orbit is approximately -5.8x10^10 J, while the total energy on the Earth's surface is about -1.25x10^11 J, leading to a required energy difference of around 6.7x10^10 J for orbital insertion. The distinction between work done and energy required was emphasized, highlighting that both lifting the satellite and providing kinetic energy are necessary for successful orbital placement.
quarklet
Messages
6
Reaction score
0
The following question deals with planetary motion: energy totals and binding energy. I have solved the question to the best of my ability, but I cannot get the right answer! I don't know what I am doing wrong, and would greatly appreciate it if someone could point out my mistakes.

Homework Statement


This is a two part question.

1. a) What is the total amount of energy needed to place a 2000 kg satellite in circular Earth orbit, at an altitude of 500km?

b) How much additional energy would have to be supplied to the satellite once it was in orbit, to allow it to escape from the Earth's gravitational field?

Homework Equations



a) Etot = 1/2 Eg
Etot = 1/2 -(GMm)/d

b) Etot > Eg

The Attempt at a Solution



a) m = 2000 kg
M = mass of Earth = 5.98x10^24 kg
d = 500 000 m + 6.38x10^6 (radius of earth)
d = 6.88x10^6 m

Etot = 1/2 Eg
Etot = 1/2 -(GMm)/d
Etot = 1/2 -(6.67x10^-11)(5.98x10^24)(2000)/6.88x10^6
Etot = - 6.0x10^7 J

However - the correct answer is 6.7x10^7. That seems like a big difference - does anyone know what I am doing wrong?

b) I know I am being asked for the binding energy - the extra amount of energy required to break free of the gravitational field of the earth, also known as Etot. My total energy is - 6.0x10^7 J, so I assume I would need + 6.0x10^7 J to overcome it.
However - the correct answer is 5.8-x10^10 J.

Please point me in the right direction if you can.
 
Last edited:
Physics news on Phys.org
quarklet said:
1. a) What is the total amount of energy needed to place a 2000 kg satellite in circular Earth orbit, at an altitude of 500km?

b) How much additional energy would have to be supplied to the satellite once it was in orbit, to allow it to escape from the Earth's gravitational field?

Homework Equations



a) Etot = 1/2 Eg
Etot = 1/2 -(GMm)/d

b) Etot > Eg

The Attempt at a Solution



a) m = 2000 kg
M = mass of Earth = 5.98x10^24 kg
d = 500 000 m + 6.38x10^6 (radius of earth)
d = 6.88x10^6 m

Etot = 1/2 Eg
Etot = 1/2 -(GMm)/d
Etot = 1/2 -(6.67x10^-11)(5.98x10^24)(2000)/6.88x10^6
Etot = - 6.0x10^7 J

However - the correct answer is 6.7x10^7. That seems like a big difference - does anyone know what I am doing wrong?
Check your math. I get 5.8x10^10 for the gravitational potential in orbit. You have found the gravitational potential energy of the satellite in orbit but you have not determined the amount of energy added to get it from the Earth's surface to orbit.

b) I know I am being asked for the binding energy - the extra amount of energy required to break free of the gravitational field of the earth, also known as Etot. My total energy is - 6.0x10^7 J, so I assume I would need + 6.0x10^7 J to overcome it.
However - the correct answer is 5.8-x10^10 J.

Please point me in the right direction if you can.
Your method is right for b).

AM
 
Last edited:
Thank-you for your reply!

a) Oh, so is this question asking how much work is required to move the satellite from the surface of the Earth to an orbit 500 000 m away? That makes sense.

W = Egf - Egi
W = mgh - mgh
W = (2000)(9.8)(6.88x10^6) - (2000)(9.8)(6.38x10^6)
W = -1.35x10^11 - (-1.25x10^11)
W = -1.0x10^10??

Sorry, I still do not understand what I am doing wrong - I would appreciate further help!

Check your math. I get 5.8x10^10 for the gravitational potential in orbit.

I tried this question again using the quicker "Eg = mgh" method, since I have the constant ag (9.8 m/s'2), but I calculated the gravitational potential in orbit to be -1.35x10^11. Argh!
 
Last edited:
quarklet said:
Thank-you for your reply!

a) Oh, so is this question asking how much work is required to move the satellite from the surface of the Earth to an orbit 500 000 m away? That makes sense.

W = Egf - Egi
W = mgh - mgh
W = (2000)(9.8)(6.88x10^6) - (2000)(9.8)(6.38x10^6)
W = -1.35x10^11 - (-1.25x10^11)
W = -1.0x10^10??

Sorry, I still do not understand what I am doing wrong - I would appreciate further help!
(I may have confused you with my previous response. I should have said the orbital energy is -5.8x10^10J, not the gravitational potential in orbit. The gravitational potential is double that, or -11.6x10^10J.)

Determine the gravitational potential energy of the satellite on the surface:

Us = -GMm/R = -6.67x10^-11 x 5.98x10^24 x 2x10^3/6.38x10^6 = -1.25x10^11 J

Determine the potential energy in orbit at a distance of Earth's radius + 500 km:

Uo = -GMm/(R+5e5) = -6.67x10^-11 x 5.98x10^24 x 2x10^3/6.88x10^6 = - 11.6x10^10 J

Its kinetic energy is 0 while on the Earth (ignoring motion due to rotation of the earth).

Putting it in orbit of 500 km requires giving it a kinetic energy of GMm/2r (for orbit, F = GMm/r^2 = mv^2/r so GMm/2r = mv^2/2 = KE), so when in orbit its kinetic energy is -half of the potential energy: 5.8x10^10 J.

The total energy, therefore in orbit is -5.8x10^10J.

The total energy on the surface is -1.25x10^11 J, so the difference is: ____

For b), the total energy when it just escapes is 0. What is the difference between that an the total energy in orbit?
I tried this question again using the quicker "Eg = mgh" method, since I have the constant ag (9.8 m/s'2), but I calculated the gravitational potential in orbit to be -1.35x10^11. Argh!
You cannot use mgh because g decreases as r increases. It would be close though.

AM
 
Last edited:
YES! : ) It makes sense! First, thank-you for clarifying the orbital vs. gravitational potential energy; second, thank-you for guiding me through the calculations for part A. I was having a difficult time keeping my concepts and formulas straight while working with large numbers.

Here is my final work for the question:

a) I now know I am *not* being asked for work (the question would have needed to use the word "work" if this was the case). I simply need to find the *difference* in *total* energies.

Total energy in orbit is equal to 1/2 Eg (which is the same as Kinetic energy, only the total energy is negative).

Etot in orbit = 1/2 Eg
Etot = 1/2 -(GMm)/d
Etot = 1/2 -(6.67x10^-11)(5.98x10^24)(2000)/6.88x10^6
Etot = -5.88x10^10 J

(originally, I made a silly calculation error here and rounded up)

Etot on Earth = Eg (no kinetic energy from satellite yet)
Etot = -(GMm)/d
Etot = -(6.67x10^-11)(5.98x10^24)(2000)/6.38x10^6
Etot = -1.25x10^11

But I want to find the amount of energy required to put satellite into orbit, and I already have gravitational potential on earth, so I calculate the difference between the energy totals.

Etot = Etot_final - Etot_initial
Etot = -5.88x10^10 - (-1.25x10^11)
Etot = 6.62x10^11

If I had used -5.8x10^10, it would have worked out perfectly.

------

I think what confused me the most was the concept of "work" vs. "amount of energy required to put object into orbit." The formula for work is Egf - Egi, but I was not asked for work, so I needed to deal with energy totals, *and* take the surface of the Earth into account as there is energy to begin with. Hooray! It makes sense!

Thank-you once again for your help! :smile:
 
Last edited:
quarklet said:
Etot in orbit = 1/2 Eg
Etot = 1/2 -(GMm)/d
Etot = 1/2 -(6.67x10^-11)(5.98x10^24)(2000)/6.88x10^6
Etot = -5.88x10^10 J
Check your arithmetic here. I get -5.80x10^10 J.
Etot on Earth = Eg (no kinetic energy from satellite yet)
Etot = -(GMm)/d
Etot = -(6.67x10^-11)(5.98x10^24)(2000)/6.38x10^6
Etot = -1.25x10^11

But I want to find the amount of energy required to put satellite into orbit, and I already have gravitational potential on earth, so I calculate the difference between the energy totals.

Etot = Etot_final - Etot_initial
Etot = -5.88x10^10 - (-1.25x10^11)
Etot = 6.62x10^11
Check your math again and use -5.80x10^10 J for the orbital energy. You are out by a factor of 10. It should be 6.7x10^10 J.

I think what confused me the most was the concept of "work" vs. "amount of energy required to put object into orbit." The formula for work is Egf - Egi, but I was not asked for work, so I needed to deal with energy totals, *and* take the surface of the Earth into account as there is energy to begin with. Hooray! It makes sense!
Careful. The amount of work done on the satellite and the amount of energy added are identical.

It is not sufficient to simply lift the satellite to 500 km above the earth. You also have to give it enough kinetic energy that it stays out there. Lifting it and giving it kinetic energy requires doing an amount of work that is equal to the change in total energy of the satellite (work = change in kinetic and potential energy: W = \Delta U + \Delta KE)

AM
 
Last edited:
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Thread 'A bead-mass oscillatory system problem'
I can't figure out how to find the velocity of the particle at 37 degrees. Basically the bead moves with velocity towards right let's call it v1. The particle moves with some velocity v2. In frame of the bead, the particle is performing circular motion. So v of particle wrt bead would be perpendicular to the string. But how would I find the velocity of particle in ground frame? I tried using vectors to figure it out and the angle is coming out to be extremely long. One equation is by work...
Back
Top