Air pressure difference in inside and outside of house

AI Thread Summary
Air pressure inside a house is equal to outside atmospheric pressure, approximately 101,325 Pa, because the air inside is subject to the same force exerted by the weight of the air above. The walls of a house, similar to a balloon, cannot withstand significant pressure differences, which keeps internal and external pressures balanced. This balance means that the air inside the house is not significantly different in pressure from the air outside, despite the lower volume of air inside. The analogy of a scale under a pile of bricks illustrates that the pressure exerted by air remains consistent regardless of the environment. Understanding this concept is essential for anyone curious about air pressure dynamics.
fsb257
Messages
1
Reaction score
0
Pressure is defined like FORCE/SURFACE [Pa] so the outside pressure close to the Earth is atmosphere pressure (101 325 Pa) defined by the mass of air/surface.Why is the same pressure in my house? There isn't much air like in outside...Thanks for the potential answer an sorry for the bad english.
 
Physics news on Phys.org
Good question, should be asked by anyone who thinks about air pressure.

Air pressure of 100kPa is about 10 tons/m^2
The walls of your house can't withstand this sort of pressure, the are like the soft walls of a balloon.
So the huge force of the air pressing down on the roof also presses down on the air inside to give the same force.

Picture the air like a pile of bricks on a weighing scale, now put a thin piece of paper between two of the brick to represent the roof of the house, it doesn't change the weight on the scale.
 
If i put a bathroom scale on the bottom of a pool , would the scale read greater less or the same , it would read the same .
 
cragar said:
If i put a bathroom scale on the bottom of a pool , would the scale read greater less or the same , it would read the same .

Not if you're standing on it.
Above the pool, your weight read, say, 150.
Bottom of pool your weight reads, say, 75 or possibly much less.

But I think you were just talking about the scale itself.
 
Hi there, im studying nanoscience at the university in Basel. Today I looked at the topic of intertial and non-inertial reference frames and the existence of fictitious forces. I understand that you call forces real in physics if they appear in interplay. Meaning that a force is real when there is the "actio" partner to the "reactio" partner. If this condition is not satisfied the force is not real. I also understand that if you specifically look at non-inertial reference frames you can...
I have recently been really interested in the derivation of Hamiltons Principle. On my research I found that with the term ##m \cdot \frac{d}{dt} (\frac{dr}{dt} \cdot \delta r) = 0## (1) one may derivate ##\delta \int (T - V) dt = 0## (2). The derivation itself I understood quiet good, but what I don't understand is where the equation (1) came from, because in my research it was just given and not derived from anywhere. Does anybody know where (1) comes from or why from it the...
Back
Top