[ansys] simulation of permanent magnet in 3D

AI Thread Summary
Modeling and analyzing a permanent magnet in 3D using ANSYS presents challenges, particularly when transitioning from 2D to 3D simulations. The user seeks guidance on attaching magnet attributes to a volume in ANSYS 15.0, specifically for a torus core with a permanent magnet. They have successfully solved the problem in 2D but are struggling with unsatisfactory results in 3D. The discussion emphasizes the need for detailed information when posting technical queries to receive effective assistance. Engaging in appropriate technical forums is recommended for better support.
s k gupta
Messages
4
Reaction score
0
I''m facing problem in modelling and analyzing a permanent magnet in 3D. kindly help me out.
 
Engineering news on Phys.org
Sure, S K!

Post your query in one of the technical forums here at PF. There are several mathematics and physics forums which can host your thread, but please choose only one.

Try to include as much information about your problem as you can; certainly much more info than you have provided in the previous post will be needed.
 
The problem is to model a permanent magnet with a torus core .I just wanted to know how to attach attribute of magnet to a volume in ansys 15.0. I solved the problem in 2D but in 3D the results are not satisfactory and I'm not able to point out the mistake by me. the construction could be assumed to be a regular torus core with a section of permanent magnet with Hc 100000 A/m. Just a basic BSUM static analysis would be fine. I think this would be sufficient if not kindly reply .
 
I have Mass A being pulled vertically. I have Mass B on an incline that is pulling Mass A. There is a 2:1 pulley between them. The math I'm using is: FA = MA / 2 = ? t-force MB * SIN(of the incline degree) = ? If MB is greater then FA, it pulls FA up as MB moves down the incline. BUT... If I reverse the 2:1 pulley. Then the math changes to... FA = MA * 2 = ? t-force MB * SIN(of the incline degree) = ? If FA is greater then MB, it pulls MB up the incline as FA moves down. It's confusing...
Back
Top