Calc Change in Internal Energy of Boiled Water

AI Thread Summary
The discussion centers on calculating the change in internal energy of 1 kg of water at 100 degrees Celsius when it is fully boiled into steam. The initial calculation for heat (Q) was determined to be 2,260,000 J, while the work done (W) was incorrectly calculated, leading to a significant error in the final internal energy (U) value. Participants pointed out that the work should be calculated using the correct volume in liters, resulting in a revised W value of -168,670 J. After adjustments, the final internal energy calculation yielded a value of 2.09E6 J. The conversation highlights the importance of unit consistency and significant figures in thermodynamic calculations.
cowgiljl
Messages
63
Reaction score
1
Seem to have ran into a brick wall with this problem
Determine the change in internal energy of 1 kg of water at 100 degrees C when it is fully boiled. Once boiled this volume of water changes to 1671 Liters of steam at 100 degrees C Assume the pressure remains constantat 1 atm

things i know
1 L =1E-3 m3
1atm = 1.013E5 N/m2
1 L = 1000 cm3 = 1E-3 m3
formulsa used
Q=mLv = 1kg*2.26E6 J/k Q=2260000 J
W = -P(Vsteam-Vwater) = (1.013E5)*[(1671000 - 1000)*.001
W = -169171E3 J

change in U = Q+W
2260000-169171000
U = -166911E3 J
If i did make a mistake i think it is where W is .
Thanks Joe
 
Physics news on Phys.org
Hmm... I can't remember if your calc. of Q is
correct but as far as W goes, if memory serves right,
I believe the conversion should be 1 Atm*Liter = 101 Joule,
and then you get:
W = - P * dV = - 1 (Atm) * (1671-1) (Liter) =
= -1670 * 101 J = -168670 J

Live long and prosper.
 
Originally posted by cowgiljl
W = -P(Vsteam-Vwater) = (1.013E5)*[(1671000 - 1000)*.001
W = -169171E3 J
In your equation, you have the volumes in cubic cm instead of liters. You should have:
W = -P(Vsteam-Vwater) = (1.013E5)*[(1671 - 1)*.001]

(This is consistent with drag's calculation.)

Also, 3 significant figures in your answer is plenty.
 
Last edited:
Now if my Q is right and I use drags and Doc Als conversion then U is equal to 2.09E6 J
is that correct

these were some of the homework questions i didn't finish

Thanks alot

Joe :smile:
 
Thread 'Collision of a bullet on a rod-string system: query'
In this question, I have a question. I am NOT trying to solve it, but it is just a conceptual question. Consider the point on the rod, which connects the string and the rod. My question: just before and after the collision, is ANGULAR momentum CONSERVED about this point? Lets call the point which connects the string and rod as P. Why am I asking this? : it is clear from the scenario that the point of concern, which connects the string and the rod, moves in a circular path due to the string...
Back
Top