Can a wind tunnel simulate a scramjet?

  • Thread starter Thread starter Apollo19
  • Start date Start date
  • Tags Tags
    Wind Wind tunnel
AI Thread Summary
Wind tunnels can simulate scramjet speeds, specifically between Mach 6-12, but the test durations are typically very short due to the high pressures required. Facilities like NASA Glenn Research Center can reach Mach 5-7 for about five minutes. Testing high-velocity air-breathing engines is conducted in these wind tunnels, as untested engines would not be safely flown on aircraft. However, achieving accurate simulation requires matching Mach number, Reynolds number, and stagnation enthalpy, which is challenging and often results in compromises. Overall, while wind tunnels can simulate scramjet conditions, achieving precise testing parameters remains complex.
Apollo19
Messages
5
Reaction score
0
Can a wind tunnel get up to scramjet speeds; ie. Mach 6-12?
 
Engineering news on Phys.org
NASA Glenn Research Center has a hypersonic tunnel used for propulsion research that can reach Mach numbers between 5-7 and has about a 5 minute run time.

Many facilities that reach these speeds have very short run times because they are driven by releasing high pressure gas from an upstream reservoir. The tunnel can run until the reservoir is sufficiently used up.
 
Thank you. Do they test high velocity air-breathing engines like that, or using a more trial by fire method?
 
They definitely test these engines in wind tunnels. Ramjets and scramjets only work at high velocities and there is no way they would stick something untested on an aircraft and try to fly it.
 
There are numerous wind tunnels capable of that Mach number but that's not all you need to properly simulate the engine. You need something that can achieve the same Mach number, Reynolds number and stagnation enthalpy, and that is hard to come by. Most of the time you have to sacrifice one or more of those and limit the test to parameters not affected by the ones you had to let slide.
 
Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly

Similar threads

Back
Top