Converting Earth's Radius to Surface Area and Volume | Conversion Help

  • Thread starter Thread starter Darkhrse99
  • Start date Start date
AI Thread Summary
To convert Earth's radius of 6.37x10^6 meters to surface area and volume, use the formulas for a sphere: surface area is 4πR² and volume is (4/3)πR³. After calculating the surface area in square meters, convert it to square kilometers by dividing by 1,000,000, since 1 km² equals 10^6 m². For volume, convert the result from cubic meters to cubic kilometers by dividing by 1,000,000,000, as 1 km³ equals 10^9 m³. Following these steps will yield the surface area in km² and volume in km³.
Darkhrse99
Messages
9
Reaction score
0

Homework Statement


The Earth's radius is 6.37x10^6 meters. I need to convert this to surface area in km^2 and it's volume in cubic kilometers.


I'm not sure where to start on either one.



Thanks
Jason
 
Physics news on Phys.org
Do you know the formula for the surface area/volume of a sphere?
 
Surface area is 4pi R^2 and surface volume is 4pi R^3
 
Darkhrse99 said:
Surface area is 4pi R^2 and surface volume is 4pi R^3

Note that the volume is \frac{4}{3} \pi r^3

So just put the radius into the formulas and for the surface area, the answer will be in m2. To convert, think of it like this:


1km2=1km*1km=1000m*1000m=106m2

Hence 1km2=106m2

Similary do the same for 1km3 and you'll get it out.
 
Thanks.
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top