Deep Inelastic Scattering, peak of cross section, width?

AI Thread Summary
The discussion focuses on deep inelastic scattering of low-energy electrons from a proton target, specifically analyzing the peak cross section at E'=4.14 GeV associated with the Δ+ resonance. The mass of the baryon is calculated using the invariant mass of the hadronic system, W, which is given as 1.18 GeV. The width is a point of confusion, with references to the uncertainty principle and its relationship to lifetime, but no clear formula provided in the textbook. Suggestions include considering classical treatments of scattering and relating the electron's perihelion distance to the baryon's radius for width estimation. The conversation highlights the complexity of the topic and the need for clarity on the relationship between width, lifetime, and energy measurements.
binbagsss
Messages
1,291
Reaction score
12
I'm looking at deep inelastic scattering of a low-energy
arrow-10x10.png
inelastic electron scattering from a stationary proton target
arrow-10x10.png
. I am given ##E## and ## \theta ## where ##\theta ## is the scaterring angle.
##E=4.879 GeV , \theta=10^{0} ##

I am given a figure of cross section ##\frac{d^{2}\sigma}{d\Omega dE'} ##

The question says the peak at ##E'=4.14GeV## is due to the production of the ##\Delta^{+}## resonance. Calculate the mass and width of the baryon?

Solution:

Mass: to get the mass we use the invariant mass of the hadronic system, ##W##, where ##W=W(E')## has already been attained in another part of the question, so this is fine , I just plug in.

Width: I'm really stuck on this one, the textbook I'm using doesn't give any formula . It just says ##W=1.18Gev## therefore the width is ## 110MeV ##

I have no idea what to do. All I can think of is the uncertainty principle, but I'm a bit confused using this in natural units. Everything is measured in energy
arrow-10x10.png
, my textbook related ##W## to the lifetime , so surely ##W## can't be relateed to some other quantity too?

I know that ##p=E'##, ##p## the momentum of the scattered electron, as the question says electron mass can be neglected.

I'm new to this topic and struggling , your assistance is greatly appreciated !
 
Physics news on Phys.org
Hmm. You could treat the problem classically. There is quite a bit of material out there on Rutherford scattering by charged particles, the Symon textbook comes to mind. The electron's perihelion distance (if you consider it as an orbit with the target as a foci) should be the baryon's radius, which you could double to find the width.

This is only a suggestion, there may be a more direct approach, but since you are given the scattering angle and energy, orbits were the first thing that came to mind when I read this.

Good luck!
 
fhc6791 said:
Hmm. You could treat the problem classically. There is quite a bit of material out there on Rutherford scattering by charged particles, the Symon textbook comes to mind. The electron's perihelion distance (if you consider it as an orbit with the target as a foci) should be the baryon's radius, which you could double to find the width.

This is only a suggestion, there may be a more direct approach, but since you are given the scattering angle and energy, orbits were the first thing that came to mind when I read this.

Good luck!

thanks for your reply. I'm pretty sure the method you refer to has not been covered in our course.
And whilst the textbook uses an uncertainty relation between W and the lifetime, it also has a table stating lifetime and width are related by the uncertainty principle.
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top