Deviation of Real Gases under Low Temp & High Pressure

AI Thread Summary
The discussion centers on the behavior of real gases, particularly carbon dioxide, nitrogen, and hydrogen, under low temperature and high pressure conditions. It highlights that carbon dioxide deviates more from ideal gas behavior than nitrogen and hydrogen due to its higher boiling point and liquefaction temperature. Liquefaction refers to the process of turning a gas into a liquid, which is closely related to the gas's boiling point. The Ideal Gas Law is applicable under low pressure and high temperature, but its accuracy diminishes as conditions approach a gas's critical temperature (Tc) and critical pressure (Pc). For carbon dioxide, Tc is approximately 85°F and Pc is around 850 lb/in². Near these critical values, alternative equations of state, like the Redlich-Kwong equation, should be used for accurate predictions.
siewwen168
Messages
15
Reaction score
0
hello :-p

i want to ask about the deviation of real gases under low temperature and high pressure. :-p

my reference book states that carbon dioxide deviates more than nitrogen and hydrogen,this is because the order of boiling points of is decreasing from carbon dioxide to hydrogen.this is because carbon dioxide liquefies at a much higher temperature than nitrogen and hydrogen. :redface:

can anyone tell me what is the relationship between the ease of liquefaction and the deviation? o:)

anyway ,what is the meaning of liquefaction?is it something to do with it's boiling point?? :confused:
 
Chemistry news on Phys.org
"Liquifaction" (I think that's the correct spelling) just means turning something into a liquid. The Ideal Gas Law assumes that the space occupied by, and the forces between, the atoms/molecules of a gas can be ignored. It's a valid approach for low pressure and high temperature. But how does one define what is "low" and "high" for a particular gas? It has to do with how close the temp/pressure are to the "critical" values. The critical temperature (Tc) of a gas is that at which the gas cannot be liquified. For CO2 that's around 85 deg.F. The critical pressure (Pc) is the pressure at Tc. For CO2 it's around 850 lb/in^2. When one gets near Tc or Pc, the Ideal Gas Law is no longer accurate, and another equation of state, such as the Redlich- Kwong must be used. Hope this helped...
 
hi pack rat2,thanks for your help,i think your information is very useful to me.thanks alot.
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...
Back
Top