Different techniques of integration

  • Thread starter Thread starter DennisG
  • Start date Start date
  • Tags Tags
    Integration
AI Thread Summary
The discussion focuses on techniques for integrating the function ∫(x^3/(x+1)^10) dx. The original poster seeks clarification on their integration method and how to properly format the expression in LaTeX. Participants suggest using the tabular method and checking results with a graphing calculator for verification. A substitution method is proposed, where u = x + 1 simplifies the integration process. Overall, the conversation emphasizes the importance of correct formatting, method selection, and verification in integration.
DennisG
Messages
8
Reaction score
0
hi, we're working on different techniques of integration and I just wanted to know if I got the right answer for this...

\int\frac{x^3}{(x+1)^10} dx (the denominator should be raised to the tenth and not the 1 with a big zero after it, if someone could tell me how to raise it to a power like that, it would also be appreciated)

I only got \frac{-(x+1)^-11}{11}\times\frac{x^4}{4}

thanks
 
Last edited:
Physics news on Phys.org
First, I'll address the latex problem: x^{10} will display x^{10}. Superscripting and subscripting should be surrounded by {}.

Next, what new method are you using? You can use the tabular method (a relative of integration by parts) and I'm sure there's at least one more method.

Another thing, if you have a graphing calculator you can check your answer by evaluating the indefinate integral as a definate integral--say 0 to 1 in this case. Evaluate your answer as a definate and see if the numbers you get from both methods are the same... I evaluated the original int from 0 to 1 and got a positive number and I see the bottom will yield a negativeover the same limits, so your answer is wrong. If you show us what you've done then someone will be able to point out your mistake.

Anyway, good luck.
 
DennisG

Try this

u = x+1

so

(u-1)^3 = x^3

Do you see it now?
 
ohhhhhh
thanks a lot
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top