Do different liquids increase in density at different rates when heated?

AI Thread Summary
Heating different liquids can affect their densities at varying rates due to differences in heat capacities. When heated, some liquids may expand more quickly than others, leading to changes in density that can cause them to rise or fall in a layered column. Water requires a specific amount of heat to increase in temperature, but other liquids may behave differently, potentially heating and expanding at different rates. As liquids transition to gas, their density typically decreases due to increased volume. Understanding these principles is crucial for predicting how liquids will separate based on density when subjected to heat.
Opehelia
Messages
1
Reaction score
0

Homework Statement


We were given an assignment to place corn syrup, dish washing detergent, shampoo, water and olive oil in a beaker, along with 6 non-metal objects, to show how they would separate based on their relative densities. The last problem on the paper states: "Write a hypothesis for what you think would happen if you took your finished column and heated it in the microwave."


Homework Equations


I don't have to do anything mathematically for this.


The Attempt at a Solution


I said that if heated in the microwave, some liquids may change densities at different rates based on how fast they heat up. I know water takes 1 calorie per gram to heat 1 degree Celsius, but I am not sure about other liquids. It thought it might be possible that another liquid may heat - and expand- more quickly than others and therefore become less dense more quickly compared to other liquids, so it would rise in the column. Does this make sense or am I on the wrong track?
 
Physics news on Phys.org
According to me, density is mass / volume. When you heat up a liquid and turn it into gas, its density increases because its volume increases. However, different liquids have different heat capacities (the amount of heat required to raise the temperature by 1 degrees celcius), therefore, the rate, which is related to time, would be different for different liquids as some would take longer than others to get to the same gaseous state.

Hope that helps!
 
I multiplied the values first without the error limit. Got 19.38. rounded it off to 2 significant figures since the given data has 2 significant figures. So = 19. For error I used the above formula. It comes out about 1.48. Now my question is. Should I write the answer as 19±1.5 (rounding 1.48 to 2 significant figures) OR should I write it as 19±1. So in short, should the error have same number of significant figures as the mean value or should it have the same number of decimal places as...
Thread 'A cylinder connected to a hanging mass'
Let's declare that for the cylinder, mass = M = 10 kg Radius = R = 4 m For the wall and the floor, Friction coeff = ##\mu## = 0.5 For the hanging mass, mass = m = 11 kg First, we divide the force according to their respective plane (x and y thing, correct me if I'm wrong) and according to which, cylinder or the hanging mass, they're working on. Force on the hanging mass $$mg - T = ma$$ Force(Cylinder) on y $$N_f + f_w - Mg = 0$$ Force(Cylinder) on x $$T + f_f - N_w = Ma$$ There's also...
Back
Top