Dynamics: Incline Slope Derivation Simplification

AI Thread Summary
The discussion revolves around simplifying the equations of motion for a block on an incline subjected to an applied force at an angle. Participants clarify the nature of the applied force, debating whether it acts horizontally or at an angle, which impacts the equations used. The original poster struggles with substituting equations and simplifying expressions to solve for acceleration, expressing confusion over the arrangement of forces. There is a suggestion to utilize trigonometric identities to further simplify the equations. The conversation emphasizes the importance of accurately defining the direction of forces to correctly apply the physics involved.
Asleky
Messages
7
Reaction score
0

Homework Statement


No official problem, just a study guide fill-in-the-blanks with an extended simplification blank. Basically, no values were given, and it is a standard block on a standard slope with a north-east applied force pushing down on the block (not parallel to horizontal or vertical axis).

Homework Equations


Fnet = ma
Fnormal = Fay + Fgy
Fnormal = (Fapplied)(sinØ) + (Fgravity)(cosØ)
Fnet = Fax - Fgx - Ffk
Fnet = (Fapplied)(cosØ) - (Fgravity)(sinØ) - (Uk)(Fnormal)

The Attempt at a Solution


He asked us to substitute the second equation above into the third equation above. I am terrible at simplifying and so this is as far as I've gotten:
ma = (Fapplied)(cosØ) - (Fgravity)(sinØ) -Uk(Fapplied)(sinØ) + (Fgravity)(cosØ)
This is extremely messy and confusing, I am aware, so I am in deep gratitude to anyone taking time to help a scrub physics student like me. :D Thank you so much for any simplifying advice! I am solving for acceleration.
 
Physics news on Phys.org
Actually upon further inspection, could I somehow make it (Fapplied)(tanØ) and (Fgravity)(tanØ)? I am confident that the trig law tanØ = sinØ/cosØ will be used. At least I'm on to something :(
 
The arrangement is not clear. Are you saying that the force is acting down the slope and parallel to it?
According to this equation
Asleky said:
Fnormal = (Fapplied)(sinØ) + (Fgravity)(cosØ)
the applied force is horizontal.
 
haruspex said:
The arrangement is not clear. Are you saying that the force is acting down the slope and parallel to it?
According to this equation
the applied force is horizontal.
Yeah that's why I multiplied by sin and cos to make all the components on one axis.
 
haruspex said:
According to this equation ... the applied force is horizontal.
Asleky said:
Yeah that's why I multiplied by sin and cos to make all the components on one axis.
But you wrote in the OP:
Asleky said:
with a north-east applied force pushing down on the block (not parallel to horizontal or vertical axis)
So which is it? Is the applied force horizontal or at an angle?
 
Could you draw a FBD?
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...

Similar threads

Replies
3
Views
9K
Back
Top