Explosion of one mass into three

  • Thread starter Thread starter haroldham
  • Start date Start date
  • Tags Tags
    Explosion Mass
AI Thread Summary
A 4.2 kg object explodes into three equal mass pieces, with two pieces moving at 5.0 m/s at right angles. The conservation of momentum principle helps determine the velocity of the third piece, which is necessary for calculating the total kinetic energy. The kinetic energy of each piece can be calculated using their masses and velocities. The total kinetic energy released in the explosion is approximately 103.5 J. This calculation highlights the importance of understanding momentum and energy conservation in explosive events.
haroldham
Messages
6
Reaction score
0

Homework Statement


A 4.2 kg object, initially at rest, "explodes" into 3 objects of equal mass. Two of these are determined to have velocities of equal magnitudes (5.0 m/s) with directions that differ by 90 degrees. How much kinetic energy was released in the explosion? (that is what is the energy of the three object systems after the explosions)


Homework Equations



To be honest, my teacher did not cover this in class so I'm naked in the dark on this one.

The Attempt at a Solution



Since they are at 90 degrees to each other, one would be 5 j m/s and the other would be 5 i m/s. I am not sure where to go from there or where the third factors in.
 
Physics news on Phys.org
Since the center of mass remains the same from conservation of momentum, then first figure the velocity of the third object. (Happily you can because you know the mass of all 3 pieces are equal.)

Then you know how much KE each piece has since you know their masses and velocities.
 
Ok, thank you so much. I undertand.
 
Did you get 103.5 J?
 
Perhaps you should show your calculation?
 
Thread 'Voltmeter readings for this circuit with switches'

Thread 'Voltmeter readings for this circuit with switches'

TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
View full post »
Thread 'Correct statement about a reservoir with an outlet pipe'

Thread 'Correct statement about a reservoir with an outlet pipe'

The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
View full post »

Similar threads

Explosion and conservation of momentum problem
Replies
5
Views
3K
Center of momentum frame question:
Replies
2
Views
2K
Projectile Motion/ Explosion Mid air
Replies
6
Views
5K
The x components of the average accelerations?
Replies
33
Views
6K
How do I find the direction of C?
Replies
10
Views
2K
Confusion with "explosive" part, Conservation of Momentum
Replies
6
Views
2K
Firework problem, conservation of energy?
Replies
18
Views
2K
Find the energy which was released when the 'Death Star' was destroyed
Replies
6
Views
2K
Why Is Energy Released in Nuclear Decay Equal to Change in Binding Energies?
Replies
13
Views
1K
What is the speed of the m1 piece after the explosion?
Replies
4
Views
2K

Hot Threads

Recent Insights

Back
Top