Calculating Electric Force on q3 in Meters: A Superposition Approach

AI Thread Summary
The discussion focuses on calculating the electric force on charge q3 using the superposition principle, with charges q1, q2, and q3 located at specified coordinates. The user initially calculated the forces in the x and y components but received incorrect results from the mastering physics platform. Key points include the correct distances r13 and r23, which were clarified as 2.2m and 2m respectively, and the importance of using appropriate significant figures in calculations. The user identified a rounding error in their calculations, particularly in the y-component force, which contributed to the discrepancy. Accurate calculations and attention to detail in significant figures are crucial for successful online homework submissions.
veevee
Messages
7
Reaction score
0
(x,y) axis in meters

q1=60microC (0,1)
q2=-34microC (2,0)
q3=13microC (2,2)

Fx3=? Fy3=?

i used superposition
F(net on 3)=F13+F23

broke it down into x and y components
Fx=(kq1q3/r13^2)(x/r13)
Fy=(kq1q3/r13^2)(y/r13) - (kq2q3/r23^2)

plugging in the numbers i got
Fx=1.3
Fy=-0.4

mastering physics says its wrong, and I can't seem to figure out where I went wrong...any suggestions?
 
Physics news on Phys.org
What did you use for r13, r23, x, and y ?

Be careful regarding the direction of the forces.
 
r13=sqrt(x2+y2)=sqrt(4+1)=2.2m

r23=2m

x=2
y=1
 
It might be simply too much round-off error.

(sqrt(5))2 = 5

2.22 = 4.84
 
the problem was i was entering 1 sig fig not 2 for Fy lol...online homework submissions...they'll waste your time for the simplest reasons..thanks though :)))
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Trying to understand the logic behind adding vectors with an angle between them'
My initial calculation was to subtract V1 from V2 to show that from the perspective of the second aircraft the first one is -300km/h. So i checked with ChatGPT and it said I cant just subtract them because I have an angle between them. So I dont understand the reasoning of it. Like why should a velocity be dependent on an angle? I was thinking about how it would look like if the planes where parallel to each other, and then how it look like if one is turning away and I dont see it. Since...
Back
Top