Find Force of Friction for 990 kg Car on 4° Incline

AI Thread Summary
To find the force of friction preventing a 990 kg car from sliding down a 4° incline, the formula Ff = μmgcosθ is used, where μ is the coefficient of friction, m is the mass, g is the acceleration due to gravity, and θ is the incline angle. Assuming a typical coefficient of friction of 0.3, the calculation yields a friction force of approximately 2,886.4 N. This value represents the maximum friction force, indicating the car is on the verge of sliding. The actual friction force may vary based on specific conditions. Understanding these calculations is essential for analyzing forces acting on objects on inclines.
kimikims
Messages
36
Reaction score
0
Any help?

A(n) 990 kg car is parked on a 4 degrees incline.
The acceleration of gravity is 9.8 m/s^2.
Find the force of friction keeping the car
from sliding down the incline. Answer in
units of N.
 
Physics news on Phys.org
Newton's second law of motion states that the force on an object is equal to its mass times its acceleration.

F=ma

This means that if there is no (net!) force on an object (F=0), it has no acceleration either (a=0). This means that it's velocity doesn't change. This means that if the object is moving at a certain speed, it keeps doing so. And if the object is standing still, it keeps standing still.

With this in mind, if there is a force on our car (namely the force of gravity) and we want our car to stay still on the incline, this means we want the total force on it in the direction parallel to the incline to be 0.

You go from there.

(Hint: chose your system of coordinate parallel to the incline.)


P.S. It's A car :wink:
 
Last edited:


To find the force of friction on the car, we can use the formula Ff = μmgcosθ, where μ is the coefficient of friction, m is the mass of the car, g is the acceleration of gravity, and θ is the angle of the incline. In this case, we have μ = 0.3 (assuming a typical value for the coefficient of friction between tires and pavement), m = 990 kg, g = 9.8 m/s^2, and θ = 4 degrees.

Plugging these values into the formula, we get:

Ff = (0.3)(990 kg)(9.8 m/s^2)(cos 4°)

= 2,886.4 N

Therefore, the force of friction keeping the car from sliding down the incline is approximately 2,886.4 N. It is important to note that this is the maximum possible friction force, as it assumes the car is on the brink of sliding down the incline. The actual force of friction may be slightly lower depending on the specific conditions of the car and the incline.
 
Thread 'Minimum mass of a block'
Here we know that if block B is going to move up or just be at the verge of moving up ##Mg \sin \theta ## will act downwards and maximum static friction will act downwards ## \mu Mg \cos \theta ## Now what im confused by is how will we know " how quickly" block B reaches its maximum static friction value without any numbers, the suggested solution says that when block A is at its maximum extension, then block B will start to move up but with a certain set of values couldn't block A reach...
TL;DR Summary: Find Electric field due to charges between 2 parallel infinite planes using Gauss law at any point Here's the diagram. We have a uniform p (rho) density of charges between 2 infinite planes in the cartesian coordinates system. I used a cube of thickness a that spans from z=-a/2 to z=a/2 as a Gaussian surface, each side of the cube has area A. I know that the field depends only on z since there is translational invariance in x and y directions because the planes are...
Back
Top