Finding the time it takes to stop

  • Thread starter Thread starter missashley
  • Start date Start date
  • Tags Tags
    Time
AI Thread Summary
The discussion centers on calculating the time it takes for a 2410 kg car traveling west at 22.6 m/s to stop under an opposing force of 8880 N. The correct time to stop is determined to be approximately 6.13 seconds. However, there is confusion regarding the calculation of displacement, which is found to be around 207.93 meters. Participants emphasize the importance of correctly applying signs for acceleration, as it acts opposite to the car's initial velocity. The need for careful attention to these details is highlighted to ensure accurate results.
missashley
Messages
34
Reaction score
0

Homework Statement



A 2410 kg car traveling to the west at 22.6 m/s slows down uniformly.

How long would it take the car to come to a stop if the force on the car is 8880 N to the east? Answer in units of s

What is the car's displacement during the time it takes to stop? Answer in m

Homework Equations



d = .5at^2 + Vit

The Attempt at a Solution



2410 * 22.6 = 54466 kg*m/s (the momentum)

8880 N is also 8880 kg*m/s^2

54466 / 8880 = 6.133558559 seconds (this is right)

d = .5at^2 + Vit
d = (.5)(22.6/6.13355)(6.13355^2) + (22.6*6.13355)
d = 207.9273 m

I got the time, but when i plug in the displacement it's wrong
 
Last edited:
Physics news on Phys.org
The acceleration is directed opposite to the initial speed, so you must be careful about signs.
 
marcusl said:
The acceleration is directed opposite to the initial speed, so you must be careful about signs.

hmmmm
 
Last edited:
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Trying to understand the logic behind adding vectors with an angle between them'
My initial calculation was to subtract V1 from V2 to show that from the perspective of the second aircraft the first one is -300km/h. So i checked with ChatGPT and it said I cant just subtract them because I have an angle between them. So I dont understand the reasoning of it. Like why should a velocity be dependent on an angle? I was thinking about how it would look like if the planes where parallel to each other, and then how it look like if one is turning away and I dont see it. Since...
Back
Top