Friction Problem: Calculating Acceleration and Tension in a Pulley System

  • Thread starter Thread starter vntraderus
  • Start date Start date
  • Tags Tags
    Friction
AI Thread Summary
To solve for the acceleration of the two blocks in the pulley system, the net force acting on the system must be calculated, considering the weight of both blocks. The acceleration can be determined using Newton's second law, where the difference in weights divided by the total mass yields the acceleration in m/s². Tension in the cord can be found by analyzing the forces acting on the hanging block, leading to a formula that incorporates both the weight of the hanging block and the calculated acceleration. Clear communication of the problem setup is crucial for accurate calculations, as assumptions about friction and mass impact the results. The final answers for acceleration and tension should be presented with detailed calculations for clarity.
vntraderus
Messages
3
Reaction score
0
The weight of the block on a table is 494 N and that of the hanging block is 175 N. Ignore all frictional effects, and assuming the pulley to be massless.

(a) Find the acceleration of the two blocks.
m/s2 =?

(b) Find the tension in the cord.
N =?
 
Physics news on Phys.org
Please show your work.

Also, rereading your post, you talk about masses and then say that a pulley is frictionless. Please state the exact question, including how the situation is set up-- we're not mind-readers!
 
Last edited:

Thread 'Rolling without slipping on a curved surface'

Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
View full post »

Thread 'Struggling to understand the concept of this question (ice cube in water optics question)'

TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
View full post »

Similar threads

Pulley with friction, how to get the friction in the pulley?
Replies
23
Views
2K
Newton's law problem: Pushing 2 stacked blocks on a horizontal table
Replies
13
Views
3K
Analyzing acceleration of block on a ramp connected to a pulley
Replies
15
Views
2K
Newton's Second Law (Pulley Sustem)
Replies
3
Views
2K
2 pullies and 3 masses -Tension
Replies
18
Views
4K
Calculating acceleration of a prism and block connected to a wall through a rope and pulley
Replies
4
Views
399
Problem with two pulleys and three masses
3
Replies
102
Views
7K
Falling mass, additionally accelerated by a rope
Replies
18
Views
1K
Calculating Force and Acceleration in a Two Block System with Varying Friction
Replies
6
Views
1K
Rocket + Connected Body Dynamics problem
Replies
47
Views
3K

Hot Threads

Recent Insights

Back
Top