Get ANSYS: Where to Download Full/Trial Version

Thread starter Jones1987
Start date Mar 28, 2010
Tags

Ansys

AI Thread Summary

ANSYS software can be obtained through purchase, typically costing around £1200 per seat, or by accessing it through university licenses. Users are advised against piracy, emphasizing the importance of legal acquisition. Trial versions may be available, but specific sources were not mentioned in the discussion. It's crucial to familiarize oneself with the software ahead of exams. Exploring university resources is a recommended option for students.

Mar 28, 2010

Jones1987

Hi does anyone know where I can get a copy of ANSYS? Full or trial, as I have an exam on it in 3 weeks and would like to know the software inside out.

Thank you

Engineering news on Phys.org

Mar 28, 2010

xxChrisxx

Buy it, or use university software. Oh also buying it costs about £1200 a seat.

Remember piracy is naughty... YARRRRRRRRRRR!

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...

View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly

View full post »

Thread 'What's the most likely cause for this carbon seal crack?'

We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...

View full post »