Have You Explored Orifice Plate FlowMeters in Pipe Research?

AI Thread Summary
The discussion centers on research related to orifice plate flow meters in pipes, with a request for journal recommendations. Participants suggest consulting ASME standards for orifice plate sizing and design, noting the availability of detailed guidelines in their catalog. A specific ASME publication is mentioned, although it comes with a high cost of $195. The conversation emphasizes the importance of referencing established standards before exploring academic journals. Overall, the need for reliable resources in orifice plate research is highlighted.
Maverk
Messages
3
Reaction score
0
Hello People,

I was just wondering if any of you done any similar investigation on the following topic. Basically, i currently doing a research on orifice plate in a pipe. It would be great if you guys know any journals that i can refer to.
 
Engineering news on Phys.org
There are at least ASME standards for orifice plate sizing and such. Before diving into any journals, perhaps try some standards. I'd also try API.
 
Last edited by a moderator:
Alrite, thanks .. ill have a look on the catalog and see that if i be able to get a copy
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »

Similar threads

Calculate the pressure drop of air across an orifice?
Replies
1
Views
4K
Efficient hit detection on a shot plate with piezo disc
Replies
6
Views
2K
Orifice place to limit pressure after regulator
Replies
2
Views
2K
Pipeline pump station pipe burst modelling
Replies
2
Views
4K
Orifice plate effect on impeller flow rate
Replies
3
Views
5K
Capacitor plate current skin effect
Replies
30
Views
2K
Automotive Would someone help with a flow simulation?
Replies
5
Views
2K
Calculation of pressure variation due to fluid discharge
Replies
31
Views
7K
Bernoulli equation and parallel pipe branch
Replies
31
Views
4K
Exploring Pneumatics Engineering: From Ice Jacking to Air Bubble Systems
Replies
1
Views
333

Hot Threads

Recent Insights

Back
Top