How do I Find Average Force in a Force vs Time graph?

AI Thread Summary
To find the average force in a Force vs. Time graph, focus on the area under the curve, which represents impulse or change in momentum. The average force can be calculated by dividing the total impulse by the total time. The graph typically consists of sections where the force increases, remains constant, and then decreases. The "time-averaged force" is the constant force that would produce the same change in momentum over the same time period. Thus, the average force is derived from the impulse divided by the duration of the force application.
haroldham
Messages
6
Reaction score
0
This is really simple, but I can not remember how to find the average force in a Force vs TIme graph.
 
Physics news on Phys.org
Think about the height of a "[certain] rectangle." Think area.
 
robphy said:
Think about the height of a "[certain] rectangle." Think area.
Ok, you completely lost me, but I think I figured it out. This certain graph increases, remains constant, then decreases. Do I take the final force of each section, add it to the initial force of each section, divide that value by the time of that section, then average those together?
 
Presumably, you mean "time-averaged force".
The area under your graph is equal to the impulse (ie, the change in momentum).
The "time-averaged force" you seek is the constant force you would apply in the same amount of time in order to obtain the same change in momentum. Translate the last sentence into facts about the graph.
 
Oh, ok I get it. It is impulse divided by time.
 
Thread 'Voltmeter readings for this circuit with switches'

Thread 'Voltmeter readings for this circuit with switches'

TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
View full post »
Thread 'Correct statement about a reservoir with an outlet pipe'

Thread 'Correct statement about a reservoir with an outlet pipe'

The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
View full post »

Similar threads

Formula for the average EMF of generator
Replies
6
Views
842
Momentum: instantaneous or average?
Replies
9
Views
1K
Confused about calculating the average energy from a distribution graph
Replies
2
Views
2K
Why Is Average Thermal Power Not Negative in This Friction Scenario?
Replies
1
Views
1K
Understanding Average Speed in Graph Analysis
Replies
25
Views
2K
What is the y-component of the force by the floor on her during the collision?
Replies
15
Views
1K
How Does Impulse Relate to Momentum Change in Physics Problems?
Replies
7
Views
2K
Difficulty Understanding 'Drag Crisis' (transitionary period from laminar to turbulent flow)
Replies
1
Views
990
Two Equations for Average Velocity?
Replies
2
Views
2K
About critical damping resistance of a ballistic galvanometer
Replies
6
Views
1K

Hot Threads

Recent Insights

Back
Top