How Do You Calculate Resistance and Current in a Carbon Block Using Ohm's Law?

AI Thread Summary
To calculate the resistance of a carbon block, the formula R = pL/A is used, where p is resistivity, L is the length, and A is the cross-sectional area. The block measures 3cm in length with a square cross-section of 0.5cm by 0.5cm, leading to an area of 0.25cm². With a potential difference of 8.4V applied, users seek to determine both the resistance and the current through the block. Clarification on the block's shape, described as a cuboid, aids understanding of the problem. This discussion emphasizes the importance of visualizing the geometry for accurate calculations.
LeakyFrog
Messages
21
Reaction score
0

Homework Statement


A block of carbon is 3cm long and has a square cross section whose sides are .5cm long. A potential difference of 8.4V maintained across its length.
a)What is the resistance of the block?
b)What is the current in this resistor?


Homework Equations


R=pL/A
where p is resistivity


The Attempt at a Solution


I'm fairly certain i can solve this problem right quick if I could understand what exactly the block looked like. The description just doesn't make sense to me. I'm not sure if you can draw pictures on this or not but a picture would be helpful if someone can make one. Thanks.
 
Physics news on Phys.org
From what I've read the block is a cuboid. Imagine a square that's 0.5cm by 0.5cm, now stretch that back in the third dimension by 3cm, and Bob's your uncle. A similar shape to a packet of gum.

Juicy+fruit.gif
 
thanks dude (or dudette)! helped a bunch!
 
No worries mate.
 
Thread 'Voltmeter readings for this circuit with switches'

Thread 'Voltmeter readings for this circuit with switches'

TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
View full post »
Thread 'Correct statement about a reservoir with an outlet pipe'

Thread 'Correct statement about a reservoir with an outlet pipe'

The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
View full post »

Similar threads

Ohm's Law confusion -- How to handle an incandescent bulb?
Replies
7
Views
2K
Ohm's law and Kirchoff — What am I missing?
Replies
4
Views
2K
Ohm's Law Validity: Does it Change with Heat?
Replies
1
Views
2K
Understanding Power Equations: How Do You Solve for V2 and R in Ohm's Law?
Replies
4
Views
3K
I Resistance and specific resistance relationships
Replies
16
Views
2K
How to calculate resistance in a combined circuit using V&I
Replies
4
Views
2K
How can I represent these resistances on a diagram?
Replies
21
Views
2K
Calculating Resistance in a Circuit using Kirchhoff's Laws
Replies
9
Views
2K
Calculating current with and without internal resistance
Replies
6
Views
3K
Learning Ohm's Law: Broad vs. In-Depth?
Replies
5
Views
2K

Hot Threads

Recent Insights

Back
Top