Is this a short circuit or not?

AI Thread Summary
In the discussed circuit, a voltmeter connected to a charged capacitor does not create a short circuit due to its high resistance. While an ideal voltmeter has infinite impedance, allowing no current flow, in practice, a very small current may pass through it. This minimal current is insufficient to significantly affect the capacitor's charge. Consequently, the voltmeter will display the voltage across the capacitor, not zero. Understanding these principles clarifies the nature of voltmeters in electrical circuits.
Phyba
Messages
9
Reaction score
0
My doubt is about the circuit in the picture. The capacitor is charged ans the switch open. There's a voltimeter connected to the terminals of the capacitor.

Does a current flow through the wires of the voltimeter causing a short circuit? If not, what would happen in the circuit described? What would the voltimeter read??

I would really like to understand it.

Thank you very much!
 

Attachments

  • Cuestion1.JPG
    Cuestion1.JPG
    3.8 KB · Views: 436
Last edited:
Physics news on Phys.org
Well, actually it could never be a short circuit beacuse the voltimeter has a very high resistance, right? So there is a current and the voltimeter would read 0?

:confused::confused:
 
An ideal voltmeter presents an infinite impedance (resistance) to what it's measuring, so no current can flow through it. It's as if the voltmeter could "see" the voltage without ever touching the circuit in any way.
 
Phyba said:
Well, actually it could never be a short circuit beacuse the voltimeter has a very high resistance, right? So there is a current and the voltimeter would read 0?

:confused::confused:

What is a short circuit? What is the usual electrical resistance through a short circuit?

As you say, the voltmeter is designed to have a very high resistance, ideally taken as infinite. Ideally, the current through the voltmeter is zero, but in reality there is a very small current passing through it (necessary for the needle to swing to register the voltage across its terminals). But the current is low enough that you can generally consider it not to affect the charge on the capacitor (even if it discharges very slightly through the voltmeter).
 
Phyba said:
Well, actually it could never be a short circuit beacuse the voltimeter has a very high resistance, right? So there is a current and the voltimeter would read 0?

:confused::confused:

Yes the Voltimeter has a very high resistance so there will be a very small current. The voltimeter will not read zero. It will read the voltage at the capacitor. That's why it's called a voltimeter.
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top