Live Feed Drone Camera: Infrared/Night Vision & Clarity

AI Thread Summary
The discussion focuses on finding affordable live feed drone cameras equipped with infrared and night vision capabilities while maintaining good picture clarity. Participants emphasize the need for clarity on the user's specific requirements, including the definition of "good picture" and "minimum price." There is a consensus that night vision technology tends to be costly, which may contradict the request for a budget-friendly option. Additionally, local laws can impact the availability of such drones. Overall, the conversation highlights the challenges of balancing quality and affordability in night vision drone cameras.
Aero_Arnendu
Messages
10
Reaction score
1
please refer some live feed drone camera with infrared and night vision and good picture clarity in minimum price . thank you
 
Last edited by a moderator:
Engineering news on Phys.org
  • Like
Likes Mech_Engineer, Nidum and phinds
I agree with Dave, please tell us about teh searching you've done so far. Why do you need a night vision drone? How do you define "good picture" and "minimum price"?

As a point of fact, I'd say your requirements are contradictory since night vision cameras as a general rule are expensive, and many times difficult to purchase depending on your local laws.
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »
Thread 'What's the most likely cause for this carbon seal crack?'

Thread 'What's the most likely cause for this carbon seal crack?'

We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...
View full post »

Similar threads

That's Not a Drone!
2
Replies
67
Views
5K
Night vision technology vs thermal imaging
Replies
7
Views
2K
I How is IR ink able to be seen with specialized filters?
Replies
3
Views
3K
Can Human Night Vision Outperform a Flashlight?
Replies
3
Views
2K
Gyroscopic stabilization and the cameras used in MotoGP on-bike video feeds
Replies
2
Views
2K
Sensor "pixels" count vs digital image output pixels count
Replies
8
Views
2K
Film Advance system research for DIY Camera
Replies
4
Views
3K
I Unidentified Luminescent Phenomena (ULP)
Replies
1
Views
3K
B Infrared Detectors & The 2nd Law of Thermodynamics
4
Replies
152
Views
9K
Lens Question for Design of an Infrared Spotlight
Replies
6
Views
2K

Hot Threads

Recent Insights

Back
Top