Question about motor efficiency and its electrical "power" rating

  • Thread starter Thread starter checkmatescott
  • Start date Start date
  • Tags Tags
    Fan Motor oven
AI Thread Summary
The discussion clarifies that the 15-watt rating of the oven fan motor refers to its input power, not output. It emphasizes that input power is typically easier to measure for electrical devices, ensuring safety by preventing circuit overloads. Participants note that output power is rarely labeled unless explicitly stated. The conversation also highlights historical context, comparing modern measurements to the less reliable "Horse Power" used in the past. Overall, understanding the distinction between input and output power is crucial for evaluating motor efficiency.
checkmatescott
Messages
80
Reaction score
2
i have an oven fan motor and its rated at 15watts, is this output or consuption if its the output whats the efficiency, how many watts is needed to make it run at full capacity thanks i n advance
 
Engineering news on Phys.org
I believe that is the input power. I can't say that I've ever looked at an electrical device and seen a rating for output power that wasn't clearly labeled as such. It wouldn't make much sense to state the output power but not the input, as electrical safety would seem to require that the input be labeled to avoid overloading the circuit.
 
  • Like
Likes russ_watters
thank you
 
  • Like
Likes russ_watters
Yes, it's input power in normal operation.
 
  • Like
Likes sophiecentaur
DaveE said:
Yes, it's input power in normal operation.
For pretty well every kind of machine, the input power is much easier to measure, for a start. Even steam engines have measurable cylinder dimensions and boiler pressure but it's anyones guess how well it will pull trucks up a hill or plough a field. 'Horse Power' used to be based more on a salesman's promise than anything else.
 
How did you find PF?: Via Google search Hi, I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere. The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary The bubble is formed at the tip...
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'd like to create a thread with links to 3-D Printer resources, including printers and software package suggestions. My motivations are selfish, as I have a 3-D printed project that I'm working on, and I'd like to buy a simple printer and use low cost software to make the first prototype. There are some previous threads about 3-D printing like this: https://www.physicsforums.com/threads/are-3d-printers-easy-to-use-yet.917489/ but none that address the overall topic (unless I've missed...
Back
Top