Oblique Elastic Collision Angle Calculation

AI Thread Summary
To solve an oblique elastic collision problem, it's essential to apply the conservation of momentum and energy principles. In the scenario with two identical marbles, one moving and the other stationary, the initial marble continues at a 55-degree angle after the collision. A vector diagram is crucial for visualizing the momentum conservation equations, as momentum is a vector quantity. By combining the equations for momentum and kinetic energy, the angle between the directions of the two marbles can be determined. Understanding these concepts is key to solving similar collision problems effectively.
kingjoshie
Messages
2
Reaction score
0

Homework Statement


I am unsure about how to go about solving an oblique elastic collision question, I understand that momentum is conserved and how to calculate momentum but unsure as to how to calculate the vectors.

The question is : A 45g marble collides with an identical stationary marble, and continues at 55 degrees to it's original direction. The collision is perfectly elastic. What is the angle between the direction taken by the target ball and the original direction of the incident ball?

Homework Equations

p=mv, not too sure how other equations are set up.


The Attempt at a Solution

I calculated the force of momentum of both the balls and the direction but drew a total blank.
 
Physics news on Phys.org
Momentum is conserved. Write a momentum conservation equation, realizing that momentum is a vector. (Hint: Draw a vector diagram illustrating that equation.)

The fact that the collision is elastic will give you another conservation equation. Combine those two equations to figure out the angle between the final velocities of the marbles.
 
Hi, Thanks a lot, I was having a hard time understanding that part but you definitely cleared it up.
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top