Pi/2 Translational Difference in y(x,t) Equations

AI Thread Summary
The discussion highlights a translational difference of π/2 between the cosine and sine forms of the wave equation, y(x,t)=Acos(kx-ωt) and y(x,t)=Asin(kx-ωt). This difference is attributed to initial conditions, which are often not critical for ideal sound wave calculations. Both equations ultimately yield the same results for wave motion, as they represent the same physical phenomenon measured from different reference points. The choice between sine and cosine can depend on the specific calculations being performed. Understanding this equivalence is essential for approaching wave equations in physics.
Helicobacter
Messages
158
Reaction score
0
In my text
y(x,t)=Acos(kx-ω t)
In the teacher's handout:
y(x,t)=Asin(kx-ω t)
There's a translational difference of pi/2 between them! I don't know which one to use for the test :S
 
Physics news on Phys.org
hehe, its just a matter of initial condition (with difference of pi)
and thereotically an ideal sound wave is usually calculated for a stablized value which means the initial condition doesn't matter much.. very seldom do we need to know its initial condition..
so no matter sin or cos will end up with e same results.
and u can use either one u want due to different kinds of calculations
 
To be accurate, there's a translational difference of pi/2k between them.

Or looking at it a different way, there is a time difference ot pi/2ω

As zergju says, they both represent "the same wave motion", but measured relative to differet points in space and/or time.
 
That was helpful, thanks
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top