Rocket accelaation at the start of fuel burn

  • Thread starter Thread starter nag
  • Start date Start date
  • Tags Tags
    Fuel Rocket
AI Thread Summary
The discussion revolves around calculating the acceleration of a rocket at the start of fuel burn while correcting its trajectory towards Mars. The rocket has a mass of 420 kg and burns 5 kg of solid fuel in 13 seconds, with an exhaust velocity of 3650 km/hr. Participants emphasize using the momentum conservation principle and the formula F = dp/dt = vdm/dt to determine the net force and resulting acceleration. The calculated net force is approximately 389.96 N, leading to an acceleration of about 0.93 m/s² when divided by the rocket's initial mass. The conversation highlights the importance of understanding how acceleration changes during the fuel burn.
nag
Messages
5
Reaction score
0
Hi Guys this is the problem I am stuck at:

The solid fuel of a 420.0 kg rocket traveling at 18100.0 km/hr is ignited to correct the rocket trajectory in mid-flight to Mars. 5.00 kg of fuel is burnt in 13.0 s. If the exhaust velocity of the fuel, relative to the rocket, is 3650.00 km/hr, what is the acceleration of the rocket (in m/s2) at the start of this burn?

I tried momentum conservation and unable to end up with correct accl of Rocket.

Thanks a lot
 
Physics news on Phys.org
nag said:
Hi Guys this is the problem I am stuck at:

The solid fuel of a 420.0 kg rocket traveling at 18100.0 km/hr is ignited to correct the rocket trajectory in mid-flight to Mars. 5.00 kg of fuel is burnt in 13.0 s. If the exhaust velocity of the fuel, relative to the rocket, is 3650.00 km/hr, what is the acceleration of the rocket (in m/s2) at the start of this burn?

I tried momentum conservation and unable to end up with correct accl of Rocket.
Use F = dp/dt = vdm/dt.

The rate of change of momentum of the rocket exhaust gives you the net force on the rocket. So you should be able to determine the acceleration at the beginning of the burn. Why is it (slightly) different at the beginning than at the end of the burn?

AM
 
Thanks for the help. It is obvious that backward thrust imposes forward force on rocket. In this case as the fuel start to burn I guess rocket gains a little acceleration. Please correct me If I am wrong or missing any.
 
Andrew Mason said:
Use F = dp/dt = vdm/dt.

The rate of change of momentum of the rocket exhaust gives you the net force on the rocket. So you should be able to determine the acceleration at the beginning of the burn. Why is it (slightly) different at the beginning than at the end of the burn?

AM
Thanks for the help. It is obvious that backward thrust imposes forward force on rocket. In this case as the fuel start to burn I guess rocket gains a little acceleration. Please correct me If I am wrong or missing any.
 
Andrew Mason said:
Use F = dp/dt = vdm/dt.

The rate of change of momentum of the rocket exhaust gives you the net force on the rocket. So you should be able to determine the acceleration at the beginning of the burn. Why is it (slightly) different at the beginning than at the end of the burn?

AM
Hi,

I followed your reply and net force on rocket = (1013.89 m/s)(5/13)kg/s = 389.96N

Since F=ma => a = 389.96 / 420(the initial mass)

Is this right way of doing. Thanks.
 
nag said:
Hi,

I followed your reply and net force on rocket = (1013.89 m/s)(5/13)kg/s = 389.96N

Since F=ma => a = 389.96 / 420(the initial mass)

Is this right way of doing. Thanks.
Looks right.

AM
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Trying to understand the logic behind adding vectors with an angle between them'
My initial calculation was to subtract V1 from V2 to show that from the perspective of the second aircraft the first one is -300km/h. So i checked with ChatGPT and it said I cant just subtract them because I have an angle between them. So I dont understand the reasoning of it. Like why should a velocity be dependent on an angle? I was thinking about how it would look like if the planes where parallel to each other, and then how it look like if one is turning away and I dont see it. Since...
Back
Top