- #1
superkaho
- 22
- 0
When the rotor is turned, it is common to measure the voltage by multimeter.
However, there is a problem that I cannot fully understand.
When I directly measure the voltage by connecting the two terminals of generator, it is found that the measurement is not same as the voltage across a load(say 50ohm) in series with the generator, why?? Which reading is more reliable?
However, there is a problem that I cannot fully understand.
When I directly measure the voltage by connecting the two terminals of generator, it is found that the measurement is not same as the voltage across a load(say 50ohm) in series with the generator, why?? Which reading is more reliable?
Last edited: