Thermodynamics, open system first law problem

Join the discussion
Ask a follow-up here, or get your own question answered by working scientists, mathematicians and engineers — people, not an autocomplete.
Real named experts · corrections over time · the nuance an AI answer skips
1 replies · 2K views
A330NEO
Messages
20
Reaction score
0

Homework Statement



>A gas flows through a small orifice in a pipe as shown above. On the higher pressure side, the gas is at 1Mpa and temperature of 300K. The pressure reduces to 1kPa after it flows through the orifice. The equation of state for the gas is
[tex]v=\frac{RT}{P}+10^{-6}T^2[/tex]
If the specific heat at constant pressure is constant at [itex]C_{p} = 1kJ/kg-k[/itex], determine the temperature on the lower pressure side of the orifice assuming no heat loss from the pipe and steady-state operation. Use the following relationship for generalized equation for enthalpy.
[tex]dh=C_{p}dT+\left [ v-T\left \{ \frac{\partial v}{\partial T} \right \}_{p}\right ]dP[/tex]

Homework Equations

The Attempt at a Solution


What I tried is to solve [itex]dh=C_{p}dT+\left [ v-T\left \{ \frac{\partial v}{\partial T} \right \}_{p}\right ]dP[/itex]. Since [itex]v=\frac{RT}{P}+10^{-6}T^2[/itex], [itex]\frac{\partial v}{\partial T}[/itex] should be [itex]\frac{R}{P}+2*10^{-6}T^2[/itex]. Thus, [itex]\frac{dh}{dT} = C_{p}-\left [ 10^{-6} \right ]\frac{dP}{dT}[/itex]. And since [itex]\frac{dh}{dT[/itex]=[itex]C_{p}[/itex], [itex]0 = \left [ 10^{-6} \right ]\frac{dP}{dT}[/itex]. No problem until this, but I can't go further because dP/dT suddenly became 0. Any help would be appreciated.
 

Attachments

  • 11_04_2015 20_03 Office Lens.jpg.jpeg
    11_04_2015 20_03 Office Lens.jpg.jpeg
    14.1 KB · Views: 628
on Phys.org