Transverse wave through a wire, and tension.

AI Thread Summary
The discussion focuses on calculating the tension in a wire based on a transverse wave equation. The wave has a linear density of 2.35 g/m and is described by the equation y(x,t) = (1.4 cm)sin[(5.45 m⁻¹)x−(6950 s⁻¹)t]. Initial calculations for maximum velocity and wave speed were attempted, leading to an incorrect tension value. Clarification was provided that 6950 is indeed the angular frequency (omega), which helped resolve the confusion. Ultimately, the correct tension was calculated as approximately 22.25 N.
jmm5872
Messages
38
Reaction score
0
A transverse wave in a wire with a linear density 2.35 g/m has the form y(x,t) = (1.4 cm)sin[(5.45 m-1)x−(6950 s-1)t].
What is the tension?


I took the A=.014m, k=5.45 /m, and \omega=6950.

I used the formula for the max velocity = A\omega
v=(.014)(6950)=97.3

Then I used the formula for the speed of a wave on a string v=\sqrt{\frac{F}{M/L}}.
97.3=\sqrt{\frac{F}{.00235}}

And I got F=22.24813

This was not the correct answer. I would appreciate any advice.

I attempted to find the velocity of the pulse : (0.943s)(3.29m)(8)=24.81976
 
Physics news on Phys.org
Try using this equation for velocity:

v=\omega/k
 
Am I right in assuming that 6950 is omega? The problem says 6950 /s, not radians/s. Is this still omega?
 
Yes, that is still omega.
 
That worked, thank you very much.
 
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Back
Top