Water's boiling point and table salt

AI Thread Summary
The discussion centers on an experiment demonstrating the effects of salt on the boiling point of water. When salt was added to boiling water, the temperature increased from 215°F to 226°F. This raised the boiling point, contrary to the belief that salt lowers it. The presence of salt allows water to reach higher temperatures before boiling, a phenomenon known as boiling point elevation. Additionally, salt lowers the freezing point of water, enabling it to remain liquid at lower temperatures. The conversation highlights the importance of understanding how solutes like salt affect the physical properties of water.
ethomas
Messages
2
Reaction score
0
I was doing a simple experiment with my class to demonstrate the boiling point of water.Two of the students wanted to see what would happen when we added salt. So, the students added about 50 ml of common table salt to less than 200 ml of boiling water. The temperature of the water immediately jumped from 215 degrees Fahrenheit, to 226 degrees Fahrenheit. I read in another thread that salt lowers the boiling point of water. Is that true? Or does it increase the boiling point? And why is this? Please use simple language as I am years past my high school chemistry class and was never very good at chemistry anyway (in college I passed only thanks to the wonderful curve!).
 
Chemistry news on Phys.org
Salt both lowers the freezing point and raises the boiling point of water.

Pure water, at sea level, boils at 100 degrees celsius (212 F). Once water begins to boil, it stops increasing in temperature, after which, all the energy that is trying to heat the water up is goin g into boiling it.
So when you dissolved all that salt into the already boiling water, you raised the boiling point, allowing the water to get hotter than it normally would have without the salt. The same is true for cooling water, salt water can get much colder without freezing into ice than pure water.
 
thanks

Thanks for your reply- it was very helpful.
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
I was introduced to the Octet Rule recently and make me wonder, why does 8 valence electrons or a full p orbital always make an element inert? What is so special with a full p orbital? Like take Calcium for an example, its outer orbital is filled but its only the s orbital thats filled so its still reactive not so much as the Alkaline metals but still pretty reactive. Can someone explain it to me? Thanks!!
I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...
Back
Top