What Are the Typical N-Values for Low Carbon Steel?

  • Thread starter Thread starter MightyQuinn11
  • Start date Start date
  • Tags Tags
    Carbon Steel
AI Thread Summary
Typical n-values for low carbon steel generally range from 0.1 to 0.3, indicating moderate strain hardening behavior. The strain hardening exponent is crucial for understanding how materials deform under stress. Various online resources, including Wikipedia, provide foundational information on strain hardening. However, specific n-values can vary based on the steel's composition and processing. For precise applications, consulting material data sheets or academic publications is recommended.
MightyQuinn11
Messages
7
Reaction score
0
I cannot find the strain hardening (n-values) for steels online anywhere. I need to see a bunch of typical values if possible. Can anyone direct me to a online website? Or atleast mention what the typical n-value is for a low carbon steel? Thanks
 
Engineering news on Phys.org

Thread 'Bubble formation in 4 mm gap vessel'

How did you find PF?: Via Google search Hi, I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere. The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary The bubble is formed at the tip...
View full post »

Thread 'HP Required to move a robot 10meters at 1.5m/sec'

I need some assistance with calculating hp requirements for moving a load. - The 4000lb load is resting on ball bearing rails so friction is effectively zero and will be covered by my added power contingencies. Load: 4000lbs Distance to travel: 10 meters. Time to Travel: 7.5 seconds Need to accelerate the load from a stop to a nominal speed then decelerate coming to a stop. My power delivery method will be a gearmotor driving a gear rack. - I suspect the pinion gear to be about 3-4in in...
View full post »
Thread 'Calculate minimum RPM to self-balance a CMG on two legs'

Thread 'Calculate minimum RPM to self-balance a CMG on two legs'

Here is a photo of a rough drawing of my apparatus that I have built many times and works. I would like to have a formula to give me the RPM necessary for the gyroscope to balance itself on the two legs (screws). I asked Claude to give me a formula and it gave me the following: Let me calculate the required RPM foreffective stabilization. I'll use the principles of gyroscopicprecession and the moment of inertia. First, let's calculate the keyparameters: 1. Moment of inertia of...
View full post »

Similar threads

How much should I adjust torque when using anti-seize?
Replies
22
Views
5K
Screw materials: AISI 316 vs A4-80
Replies
10
Views
2K
What is the Cooling Time for Steel Tubes with Ambient Nitrogen Gas Flow?
Replies
7
Views
3K
Pipe Design to pump sea water from the ocean to a boiler via intermediate tanks
Replies
4
Views
2K
I Finding yield strength with a load/displacement curve
Replies
5
Views
2K
I need to find a low deflection rectangular steel tube
Replies
6
Views
3K
How to specify carbon fibre material properties in ANSYS ACP
Replies
2
Views
11K
What Is the Emissivity of Carbon Steel for IR Thermometer Use?
Replies
5
Views
10K
3"x3" steel tube, Structural engineering question
Replies
12
Views
916
What is the ideal hardness for a steel insert used in an impacting peening gun?
Replies
2
Views
2K

Hot Threads

Recent Insights

Back
Top