Why is the bond length of HI longer than that of HCl?

AI Thread Summary
The discussion centers on the bond lengths of hydrogen halides, specifically HI and HCl, and the relationship between atomic radii and bond lengths. It highlights that despite iodine having a larger atomic radius than chlorine, the bond length of HI is actually longer than that of HCl. This is attributed to the lower electronegativity of iodine compared to chlorine, resulting in a less polar H-I bond. Consequently, there is reduced electrostatic attraction between the hydrogen and iodine atoms, allowing them to be further apart, thus increasing the bond length. The conversation emphasizes the common understanding that larger atomic radii typically correlate with longer bond lengths, reinforcing the reasoning behind the observed bond lengths in these compounds.
elemis
Messages
162
Reaction score
1
Last edited by a moderator:
Chemistry news on Phys.org
Why did you think that the larger atomic radius of iodine makes the bond length of HI smaller? Correct me if I'm wrong but it's pretty common sense that the larger the atomic radius, the longer the bond length. Besides, due to the smaller electronegativity of iodine, H-I bond is not as polar as H-Cl and therefore less electrostatic attraction due to partial charges is experienced by H and I, thus they are further apart, increasing the bond length.
 
dorebase2006 said:
Why did you think that the larger atomic radius of iodine makes the bond length of HI smaller? Correct me if I'm wrong but it's pretty common sense that the larger the atomic radius, the longer the bond length. Besides, due to the smaller electronegativity of iodine, H-I bond is not as polar as H-Cl and therefore less electrostatic attraction due to partial charges is experienced by H and I, thus they are further apart, increasing the bond length.

I was exploring other avenues of thought ;)

Thanks for the explanation.
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...
Back
Top