Work Done & Friction: Definition & Effect

AI Thread Summary
Work done is defined as the force multiplied by the distance moved in the direction of that force. In the context of a moving car, friction acts opposite to the direction of motion, resulting in negative work when the car is braking. Conversely, when the car accelerates, friction acts in the same direction as the motion, leading to positive work. The direction of friction is crucial as it opposes slipping between the tire and the road surface. Understanding these dynamics clarifies how friction influences the work done on a vehicle during different driving conditions.
Griff38
Messages
8
Reaction score
0
If work done is defined as F X distance moved in the direction of this force, is friction doing work on a moving car since if the car is moving to the right friction is actually acting to the left? or should the definition of work done be F x distance moved parallel to the line of action of this force in which case the displacement and force can be in totally opposite directions.
 
Physics news on Phys.org
If the car moves to the right but friction acts to the left, then the work done will be negative. That would be the case when braking. If the car is accelerating, then the force will point in the direction of motion and the work done will be positive.
 
Thank you so much, that's made it very clear.
 
Consider a car moving forward to the right as you look at the car. This implies the the tires rotating in a clockwise direction. As a point on the tire comes around to the bottom where it contacts the road, the direction the tire is moving relative to the road is to the left. Friction, in this case, is then applied to the tire toward the right --> in the direction of the cars motion. As previously mentioned, friction acts opposite to the direction of motion. The "motion" being the motion of the tire.
 
The direction of friction depends on whether the car is accelerating or deaccelerating. Friction acts to oppose slipping between the surfaces.
 
Hello everyone, Consider the problem in which a car is told to travel at 30 km/h for L kilometers and then at 60 km/h for another L kilometers. Next, you are asked to determine the average speed. My question is: although we know that the average speed in this case is the harmonic mean of the two speeds, is it also possible to state that the average speed over this 2L-kilometer stretch can be obtained as a weighted average of the two speeds? Best regards, DaTario
Thread 'Beam on an inclined plane'
Hello! I have a question regarding a beam on an inclined plane. I was considering a beam resting on two supports attached to an inclined plane. I was almost sure that the lower support must be more loaded. My imagination about this problem is shown in the picture below. Here is how I wrote the condition of equilibrium forces: $$ \begin{cases} F_{g\parallel}=F_{t1}+F_{t2}, \\ F_{g\perp}=F_{r1}+F_{r2} \end{cases}. $$ On the other hand...
I know that mass does not affect the acceleration in a simple pendulum undergoing SHM, but how does the mass on the spring that makes up the elastic pendulum affect its acceleration? Certainly, there must be a change due to the displacement from equilibrium caused by each differing mass? I am talking about finding the acceleration at a specific time on each trial with different masses and comparing them. How would they compare and why?

Similar threads

Replies
10
Views
2K
Replies
10
Views
2K
Replies
3
Views
1K
Replies
2
Views
16K
Replies
16
Views
2K
Replies
23
Views
2K
Back
Top