Insights AC Power Analysis: Part 3, Cyber Resilience - Comments

Click For Summary
The discussion highlights the challenges of disrupting the power grid through cyber attacks, even if cybersecurity measures are compromised. It emphasizes that individual power utilities operate with their own control centers, where SCADA systems play a crucial role. The difficulty in adopting advanced systems like EMS and Economic Dispatch is noted, particularly due to dispatchers' reluctance to move away from traditional communication methods. The conversation reflects on the historical reliance on telephones for power management, questioning the extent of concern over cyber threats to grid stability. Overall, the insights underscore the complexity of integrating technology in power utilities and the resilience of the grid against cyber vulnerabilities.
anorlunda
Staff Emeritus
Science Advisor
Homework Helper
Insights Author
Messages
11,326
Reaction score
8,750
anorlunda submitted a new PF Insights post

AC Power Analysis: Part 3, Cyber Resilience

acpoweranalysisp3.png


Continue reading the Original PF Insights Post.
 
  • Like
Likes ProfuselyQuarky
Engineering news on Phys.org
This article talks about difficulties in bringing down the power grid via hacking, even if all cyber security was defeated.
 
Fascinating and equally important!
 
Just as pertinent and beautifully written as the others. Thank you for sharing your knowledge.:smile:
 
Last edited:
Inside a region are individual power utilities Each utility has a control center overseeing their own territory. The infamous SCADA systems that critics like to criticize mostly exist at this level.
The hardest part of implementing EMS and Economic Dispatch via SCADA at the utility I worked for back then was getting the dispatchers to use the system. Computers scared them and were too use to using telephones for buying and selling power; having the power plants ramp a schedule from 10 minutes before to 10 minutes after the top of the hour. Knowing they could control their territory with just telephones, I've never understood why people were so concerned about bringing down the grid by cyber attacks.
 
  • Like
Likes mfb
Great article and we'll written.
 
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
Back
Top